Toyota FJ Cruiser (GSJ 10, 15 series). Manual — part 304
LIGHTING – HAZARD WARNING SWITCH
LI–109
LI
(b) Check the illumination operation.
(1) Connect the positive (+) battery lead to
terminals 1 and 2, and the negative (-) battery
lead to terminal 20, then check that the
illumination illuminates.
Standard:
Illumination illuminates.
If the illumination does not illuminate, replace
the integration control and panel.
INSTALLATION
1.
INSTALL INTEGRATION CONTROL AND PANEL
ASSEMBLY
(a) Engage the 4 clips and install the integration control
and panel.
(b) Install the 2 screws.
2.
INSTALL INSTRUMENT PANEL GARNISH LH (See
page
)
3.
INSTALL INSTRUMENT PANEL GARNISH RH (See
page
)
4.
CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
Battery
E127250E01
B133888
LI–110
LIGHTING – STOP LIGHT SWITCH
LI
BODY ELECTRICAL
LIGHTING
STOP LIGHT SWITCH
COMPONENTS
STOP LIGHT SWITCH
E127230E01
LIGHTING – STOP LIGHT SWITCH
LI–111
LI
REMOVAL
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
2.
REMOVE STOP LIGHT SWITCH
(a) Remove the stop light switch connector from the
stop light switch.
(b) Turn the stop light switch counterclockwise and
remove it.
INSPECTION
1.
INSPECT STOP LIGHT SWITCH
(a) Check the resistance.
(1) Using an ohmmeter, measure the resistance
and check the results in accordance with the
value(s) in the table below.
Standard Resistance
If the result is not as specified, replace the stop
light switch.
INSTALLATION
1.
INSTALL STOP LIGHT SWITCH
(a) Install the stop light switch into the adjuster until it
slightly touches the brake pedal.
NOTICE:
Do not depress the brake pedal.
E127228
E127229
1
2
3
4
Pushed in
Released
B113724E04
Tester Connection
Condition
Specified Condition
1 - 2
Switch pin released
Below 1
Ω
3 - 4
Switch pin released
10 k
Ω or higher
1 - 2
Switch pin pushed in
10 k
Ω or higher
3 - 4
Switch pin pushed in
Below 1
Ω
Adjuster
Brake Pedal
Stop Light Switch
F049043E05
LI–112
LIGHTING – STOP LIGHT SWITCH
LI
(1) Make a quarter turn clockwise to install the stop
light switch.
NOTICE:
Do not depress the brake pedal.
HINT:
The turning torque for installing the stop light
switch is as below.
Torque: 1.5 N*m (15 kgf*cm, 13 in.*lbf) or
less
(b) Check the stop light switch clearance.
Stop light switch clearance:
0.5 to 2.6 mm (0.020 to 0.102 in.)
(c) Connect the stop light switch connector to the stop
light switch.
2.
CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
Shaft
Stop Light Switch
0.5 to 2.6 mm (0.020 to 0.102 in.)
C133112E01
E127228
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст