Toyota FJ Cruiser (GSJ 10, 15 series). Manual — part 211
ET–74
EXTERIOR – OUTSIDE MOULDING
ET
2.
INSTALL BACK DOOR OUTSIDE MOULDING LH
(a) Install 6 new clips in the positions shown in the
illustration.
NOTICE:
If you install the clips wrongly, the installation of
the back door outside moulding will be
improper.
(b) Engage the 6 clips and install the back door outside
moulding.
(c) Tighten the screw.
(d) Remove the protective tape.
3.
INSTALL SPARE TIRE
Torque: 88 N*m (897 kgf*cm, 65 ft.*lbf)
B135028
B135027
Protective Tape
B135025E01
EXTERIOR – OUTSIDE MOULDING
ET–75
ET
4.
INSTALL ACCESS DOOR OUTSIDE MOULDING SUB-
ASSEMBLY
(a) Install 4 new clips in the positions shown in the
illustration.
NOTICE:
If you install the clips wrongly, the installation of
the access door outside moulding will be
improper.
(b) Engage the 4 clips and install the access door
outside moulding.
(c) Tighten the nut.
Torque: 5.0 N*m (50 kgf*cm, 44 in.*lbf)
(d) Remove the protective tape.
B135023
B135022
Protective Tape
B135020E01
ET–76
EXTERIOR – OUTSIDE MOULDING
ET
5.
INSTALL FRONT DOOR OUTSIDE MOULDING SUB-
ASSEMBLY
(a) Install 9 new clips in the positions shown in the
illustration.
NOTICE:
If you install the clips wrongly, the installation of
the rear door outside moulding will be improper.
(b) Engage the 9 clips and install the front door outside
moulding.
(c) Tighten the 2 nuts.
Torque: 5.0 N*m (50 kgf*cm, 44 in.*lbf)
(d) Remove the protective tape.
6.
INSTALL QUARTER PANEL MOULDING PAD
HINT:
Only follow this procedure when replacing the quarter
outside moulding pad.
(a) Install a new quarter outside moulding pad in the
position shown in the illustration.
B135019
B135018
Protective Tape
B135016E01
B135064
EXTERIOR – OUTSIDE MOULDING
ET–77
ET
7.
INSTALL QUARTER OUTSIDE MOULDING SUB-
ASSEMBLY
(a) Install 2 new clips in the positions shown in the
illustration.
NOTICE:
If you install the clips wrongly, the installation of
the quarter outside moulding will be improper.
(b) Engage the 2 clips and install the quarter outside
moulding.
(c) Tighten the 8 screws
Torque: 5.0 N*m (50 kgf*cm, 44 in.*lbf)
(d) Install the clip.
(e) Remove the protective tape.
8.
INSTALL FRONT FENDER OUTSIDE MOULDING PAD
HINT:
Only follow this procedure when replacing the front
wheel opening extension pad.
B135065
B135063
B135062
Protective Tape
B135061E01
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст