Ford Crown Victoria (2010 year). Manual — part 48
Passenger compartment fuse panel
The fuse panel is located below and to the left of the steering wheel by
the brake pedal. Remove the panel cover to access the fuses.
To remove a fuse use the fuse puller tool provided on the fuse panel
cover.
The fuses are coded as follows.
Fuse/Relay
Location
Fuse Amp
Rating
Protected Circuits
1
10A
Ignition (START) - Starter relay
coil, DTRS
2
7.5A
Power mirrors, Mirror switch,
Keypad switch, Decklid switch,
Adjustable pedal switch, Driver’s
door module, Cluster
3
5A
Ignition (START) - Audio mute,
Police power distribution box
(PDB) (Police vehicles only)
Roadside Emergencies
193
2010 Crown Victoria (cro)
Owners Guide, 2nd Printing
USA (fus)
Fuse/Relay
Location
Fuse Amp
Rating
Protected Circuits
4
10A
Lighting control module (LCM)
(switch illumination), Autolamp
sensor
5
7.5A
Ignition (ON/ACC) - LCM
6
7.5A
LCM
7
10A
Ignition (ON/ACC) - Wiper
module
8
10A
Electronic automatic temperature
control (EATC) module (vehicles
equipped with EATC only)
9
7.5A
Ignition (ON/ACC) - Door lock
switch illumination, Heated seat
switch illumination, Radio,
Antenna, Electrochromatic mirror,
Window relay coil, Decklid relay
coil and Police ON/ACC relay coil
(Police vehicles only)
10
15A
Hazards (non-Police vehicles
only)
20A
Hazards (Police vehicles only)
11
15A
Ignition (ON) - Turn signals
12
15A
Audio
13
10A
Ignition (ON) - rear air
suspension module (RASM),
Cluster
14
15A
Taxi, Adjustable pedals
15
10A
Ignition (ON) - EATC module,
A/C mode switch (vehicles
equipped with manual A/C only),
A/C blower relay coil
16
20A
On-board diagnostics (OBD II)
Roadside Emergencies
194
2010 Crown Victoria (cro)
Owners Guide, 2nd Printing
USA (fus)
Fuse/Relay
Location
Fuse Amp
Rating
Protected Circuits
17
10A
Ignition (ON) - A/C mode switch
(vehicles equipped with manual
A/C), Blend door, Heated seat
modules
18
15A
LCM (interior lighting)
19
10A
LCM (Left-hand low beam)
20
10A
Ignition (ON/START) - Back-up
lamps, Anti-lock brake system
(ABS)
21
10A
LCM (Right-hand low beam)
22
10A
Ignition (ON/START) - Restraint
control module (RCM), Occupant
classification sensor (OCS),
Passenger airbag deactivation
indicator (PADI)
23
15A
Multi-function switch
(Flash-to-pass), LCM (High
beams)
24
10A
Ignition (ON/START) - Passive
anti-theft system (PATS) module,
Powertrain control module (PCM)
relay coil, Fuel relay coil, Ignition
relay coil
25
15A
LCM (Park lamps, corner lamps,
license lamps)
26
10A
Ignition (ON/START) - Cluster,
LCM, Overdrive cancel switch,
Traction control switch
27
—
Not used
28
7.5A
Brake signal, LCM (brake
transmission shift interlock), ABS
29
2A
Hazard in (Police vehicles only)
Roadside Emergencies
195
2010 Crown Victoria (cro)
Owners Guide, 2nd Printing
USA (fus)
Fuse/Relay
Location
Fuse Amp
Rating
Protected Circuits
30
2A
Battery saver (Police vehicles
only)
31
5A
Key in (LCM)
32
2A
Hazard out (Police vehicles only)
33
10A
Fire suppression module (if
equipped) (Police vehicles only)
K101
Full ISO relay
Window relay, Decklid (Police
vehicles only)
Power distribution box
The power distribution box is located in the engine compartment. The
power distribution box contains high-current fuses that protect your
vehicle’s main electrical systems from overloads.
WARNING: Always disconnect the battery before servicing high
current fuses.
WARNING: To reduce risk of electrical shock, always replace
the cover to the power distribution box before reconnecting the
battery or refilling fluid reservoirs.
If the battery has been disconnected and reconnected, refer to the
Battery section of the Maintenance and Specifications chapter.
Roadside Emergencies
196
2010 Crown Victoria (cro)
Owners Guide, 2nd Printing
USA (fus)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст