Ford E-250 (2006 year). Manual — part 10

4. Remove the bulb retaining ring by
rotating it counterclockwise, and
slide the ring off the plastic base.

5. Pull the bulb straight out.

Handle a halogen headlamp bulb carefully and keep out of
children’s reach. Grasp the bulb only by its plastic base and do

not touch the glass. The oil from your hand could cause the bulb to
break the next time the headlamps are operated.

Note: If the bulb is accidentally touched, it should be cleaned with
alcohol before being used.

To install the new bulb, follow the removal procedures in reverse order.

Replacing headlamp bulbs (sealed beam)

1. Make sure headlamp switch is in the OFF position and open the hood.

2. Remove the two headlamp screws
and bezel from the headlamp
housing.

Lights

41

3. Remove the four headlamp bulb
retaining screws and the retaining
ring.

4. Remove the headlamp.

5. Disconnect the electrical
connector from the bulb and remove
the bulb.

To install the new bulb, follow the removal procedures in reverse order.

Replacing front parking lamp/turn signal bulbs

1. Make sure the headlamp control is in the OFF position.

2. Remove two screws and pull lamp assembly away from the vehicle.

3. Rotate the bulb socket
counterclockwise and remove.

4. Carefully pull the bulb straight
out of the socket.

To complete installation, follow the
removal procedures in reverse order.

Replacing high-mount brakelamp bulbs

The interior cargo lamp (if equipped), on vehicles without a rear
headliner, will have to be removed from under the high-mount brakelamp
assembly located inside the vehicle. Then:

1. Remove the two screws from the
high-mount brakelamp assembly and
lift the lamp from the vehicle.

2. Remove the bulb socket from the
lamp assembly by turning
counterclockwise.

3. Carefully pull the bulb straight
out of the socket.

To install the new bulb, follow the removal procedure in reverse order.

Lights

42

Replacing license plate lamp bulbs

1. Turn the headlamp switch to OFF
and then remove the two screws
and the license plate lamp assembly
from the rear door.

2. Remove bulb socket from lamp
assembly by turning
counterclockwise.

3. Pull the bulb out from socket and
push in the new bulb.

To install the new bulb, follow the removal procedures in reverse order.

Replacing tail lamp/turn/backup lamp bulbs

1. Turn the headlamp switch to the
OFF position and then remove the
four screws and the lamp assembly
from vehicle.

2. Rotate bulb socket
counterclockwise and remove from
lamp assembly.

3. Carefully pull the bulb straight
out of the socket and push in the
new bulb.

To install the lamp, follow the removal procedures in reverse order.

Lights

43

MULTI-FUNCTION LEVER

Windshield wiper: Rotate the end
of the control away from you to
increase the speed of the wipers;
rotate towards you to decrease the
speed of the wipers.

Windshield washer: Push the end
of the stalk:
• briefly: causes a single swipe of

the wipers without washer fluid.

• a quick push and hold: the wipers

will swipe three times with
washer fluid.

• a long push and hold: the wipers

and washer fluid will be activated
for up to ten seconds.

TILT STEERING WHEEL

To adjust the steering wheel:

1. Pull and hold the steering wheel
release control toward you.

2. Move the steering wheel up or
down until you find the desired
location.

3. Release the steering wheel
release control. This will lock the
steering wheel in position.

Never adjust the steering wheel when the vehicle is moving.

Driver Controls

44