Ford E-250 (2006 year). Manual — part 43

• Comfort and noise
• Ground clearance and parking at curbs
• Winter weather driving capability
• Wet weather driving capability
For vehicles equipped with 4WD, it is not recommended that the vehicle
be operated in 4WD modes with a temporary emergency spare tire. If
4WD operation is necessary, do not operate above speeds of 10 mph (16
km/h) or for distances above 50 miles (80 km).

3. Full-size dissimilar spare without label on wheel

When driving with the full-size dissimilar spare tire/wheel, do not:
• Exceed 70 mph (113 km/h)
• Use more than one dissimilar spare tire/wheel at a time
• Use commercial car washing equipment
• Use snow chains on the end of the vehicle with the dissimilar spare

tire/wheel

The usage of a full-size dissimilar spare tire/wheel can lead to
impairment of the following:
• Handling, stability and braking performance
• Comfort and noise
• Ground clearance and parking at curbs
• Winter weather driving capability
• Wet weather driving capability
• All-Wheel driving capability (if applicable)
• Load leveling adjustment (if applicable)
When driving with the full-size dissimilar spare tire/wheel additional
caution should be given to:
• Towing a trailer
• Driving vehicles equipped with a camper body
• Driving vehicles with a load on the cargo rack
Drive cautiously when using a full-size dissimilar spare tire/wheel and
seek service as soon as possible.

Roadside Emergencies

173

Full-size Matching Spare Tire/Wheel Information

This spare tire/wheel will match the road tire/wheel. When driving with
the full size matching spare tire/wheel, do not exceed 70 mph (113
km/h). It is intended for temporary use only. This means if you need to
use it, you should replace it as soon as possible.

Spare tire information

The spare tire for your vehicle is stowed under the rear of your vehicle
(except cutaway and stripped chassis models).

To remove the spare tire:

1. Open the rear doors and remove
the thumb screw and anti-theft
bracket. If finger pressure will not
remove the thumb screw, use the
lug wrench to loosen the screw.

2. Remove the access plug under
the left door.

3. Remove the jack handle from the
right side compartment and insert
the tip of the jack handle through
the access hole and into the tube.

4. Turn the jack handle
counterclockwise until the cable is
slack and the tire can be slid from
under the vehicle.

5. Remove the retainer from the
spare tire.

To stow the cable retainer with the spare removed, turn the jack handle
clockwise until all slack is removed.

Roadside Emergencies

174

Tire change procedure

Preparing to change the tire

To help prevent the vehicle from moving when you change a tire,
be sure the parking brake is set, then block (in both directions)

the wheel that is diagonally opposite (other side and end of the
vehicle) to the tire being changed.

1. Park on a level surface.

2. Activate the warning flashers.

3. Place the gearshift in P (Park).

4. Apply the parking brake and turn
the engine off.

5. Block the wheel that is diagonally
opposite the tire you are changing.

On E-450 vehicles, the parking
brake is on the transmission.
Therefore, the vehicle will not be
prevented from moving when a rear
wheel is lifted, even if the parking brake is applied. Be sure to block both
directions of the wheel that is diagonally opposite to the wheel that is
being lifted.

If the vehicle slips off the jack, you or someone else could be
seriously injured.

6. Remove the spare tire and jack from the storage location.

Roadside Emergencies

175

• the jack is located in the rear

right-hand side of the cargo area.

7. Use the tapered end of the lug nut wrench to unscrew wheel
ornaments attached by retaining screws. Remove any wheel trim. Insert
the tapered end of the lug nut wrench behind wheel covers or hubcaps
and twist off.

8. Loosen the wheel nut by pulling up on the handle of the lug nut
wrench about one-half turn (counterclockwise). Do not remove the
wheel lug nuts until you raise the tire off the ground.

Replacing the tire

1. Assemble the jack handle sections together and lock into the jack. Use
the jack handle to slide the jack under the vehicle.

To lessen the risk of personal injury, do not put any part of your
body under the vehicle while changing a tire. Do not start the

engine when your vehicle is on the jack. The jack is only meant for
changing the tire.

2. Position the jack to raise the front or rear wheel.

Roadside Emergencies

176