Hyundai i30 / Elantra Neos. Body repair manual — part 11
BC-32
BODY CONSTRUCTION
BFDBC6185
BFDBC6187
BFDBC6186
BFDBC6183
BFDBC6182
BFDBC6184
BFDBC6181
BFDBC6180
E - E
F - F
H - H
L - L
N - N
G - G
K - K
M - M
+
_
3.8 0.5 mm
+
_
4.5 0.5 mm
+_
4.5 0.5 m
m
+
_
3.8 0.5 mm
+
_
3.8 0.5 mm
+
_
3.8 0.5 m
m
+
_
3.8 0.5 m
m
+_
4.5 0.5 mm
Fender panel
Rear door
panel
assembly
Rear door panel assembly
Side outer panel
Front door panel
Rear door panel assembly
Rear door
panel assembly
Side sill outer panel
Rear door
panel assembly
Rear door
panel assembly
Side sill outer panel
Front door panel assemby
Front door panel assemby
Front door panel assemby
Front door
panel assemby
Front door panel assemby
BODY CONSTRUCTION
BC-33
< Cross-Sectional Views >
BFDBC6190
D
D
B
B
A
A
E
E
C
C
TAIL GATE
BC-34
BODY CONSTRUCTION
BFDBC6185
BFDBC6182
BFDBC6184
BFDBC6181
BFDBC6180
A - A
B - B
D - D
C - C
E - E
+
_
5 0.5 mm
4 mm
2 mm
3.5 mm
5 mm
+_
4 0
.5
m
m
0.5 mm
Tail gate outer panel
Tail gate inner panel
Headlining
High mounted
stop lamp
Rear glass
assemby
Tail gate panel
assembly
BD-2
BODY DIMENSIONS
ACTUAL-MEASUREMENT DIMENSIONS
1.
These dimensions indicate the actual linear distance
between measurement points, and are the reference
dimensions for use if a tracking gauge is used for
measurement.
2.
Measure by first adjusting both probes to the same
length (A=A')
CAUTION
Check the probes and gauge itself to make sure
there is no free play.
MEASUREMENT POINT
1.
Measurements should be taken at the hole center.
GENERAL
1.
Basically, all measurements in this manual are taken
with a tracking gauge.
2.
When a measuring tape is used, check to be sure there
is no elongation, twisting or bending.
3.
For measuring dimensions, both projected dimension
and actual-measurement dimension are used in this
manual.
MEASUREMENT METHOD
PROJECTED DIMENSIONS
1.
These are the dimensions measured when the
measurement points are projected into the reference
plane, and are the reference dimensions used for body
alterations.
2.
If the length of the tracking gauge probes are
adjustable, make the measurement by lengthening one
probe by the amount equivalent to the difference in
height of the two surfaces.
BMCBD6001
Projected Dimension
Height
BMCBD6003
Hole Center
BMCBD6002
Actually-Measured Dimension
A
A'
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст