Dacia Solenza (engine E7J). Service manual — part 156
84
STEERING - CONNECTOR
84 - 9
Connector
Pin
Denomination
1
Driver window lowering
2
Mass
3
Supply + after contact
4
Supply + parking
5
Driver window lifting
Driver electric window switch
84
STEERING - CONNECTOR
84 - 10
Connector
Pin
Denomination
1
Supply + parking
2
Control + signaling relay
3
Left turning lights control
4
Right turning lights control
5
Mass
6
+ Battery
7
+ Accessories
8
Control + signaling
Hazard switch
84
STEERING - CONNECTOR
84 - 11
DISMOUNTING
Disconnect the battery (-) terminal.
Dismount the upper part dashboard.
Disconnect connectors (1), (2) and (3). Mark identification of their mounting position.
Holding with one hand the fix part (4) dismount the lighter attachment clamp (5) on the lower
part dashboard.
Extract the lighter fix body (part).
REMOUNTING
Position the lighter fix body in the dashboard lower part. Holding with one hand the fix body,
mount the lighter attachment clamp. The required tightening moment is 1.5 Nm applied to the fix
body (4).
Connect the lighter connectors, observing their mounting position existent prior to dismount-
ing.
Mount the upper part dashboard.
Reconnect the battery (-) terminal.
Check the operation of the electric lighter.
REMARK:
In order to replace the bulb, dismount the lighter, dismount the bulb holder (6) from
the clamp (5) and replace the bulb.
Connectors
Connector
Denomination
1
Mass
2
Supply + after contact
3
Supply + parking
Electric lighter
85
WINDSCREEN WIPER
85 - 1
The drive mechanism is mounted in the cli-
mate control box.
DISMOUNTING
Ensure that assembly is stopped in the
position “ stopped at fix point”.
Disconnect the battery (-) terminal.
Dismount the climate control gasket.
Dismount the climate control protector
Dismount the wiring connector (1) from the
windscreen wiper electric motor (push on the
connector A point and detach from clips).
Remove the protectors (2) from shafts.
Dismount the attachment nuts (3) of the
windscreen wiper blade-arm assemblies.
Dismount the windscreen wiper blade-arm
assemblies (4). Mark the identification of their
mounting position and of the two windscreen
wiper blade-arm assemblies (left-right).
Remove the covers (5).
Dismount the shafts attachment nuts (6) on
the windscreen lower frame; recover the washers
and gaskets.
Detach from clips the washing hose.
Dismount the mechanism attachment screw
(7) on the windscreen lower crossbeam.
Extract the mechanism from the climate
control box, by rotating it.
REMOUNTING
Perform the dismounting operations in the
reverse order.
REMARK:
When mounting the drive mechanism, the
wiper electric motor must be in the position
”stopped at fix point”.
The required tightening moment of the
mechanism attachment screw (7) on the
windscreen lower crossbeam : 6-8 Nm.
The required tightening moment of the shafts
attachment nuts (6) on the windscreen lower
crossbeam: 8 ± 15 % Nm.
The required tightening moment of the
attachment nuts (3) of the windscreen wiper
blades and arms : 12 ± 15% Nm.
The required tightening moment of the
attachment screw (7) of the windscreen washing
assembly : 2 Nm.
Drive mechanism
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст