Dacia Solenza (engine E7J). Service manual — part 89
THE MECHANICAL ELEMENTS CONTROLS
37
37 - 6
DISK FILTER REPLACEMENT
DISMOUNTING
Dismount the servobrake off the vehicle.
Loosen the lock nut (E) and dismount :
- the coupling fork
- the lock nut.
Remove the disk filter (F).
REMOUNTING
Mount :
- the new disk filter
- the lock nut;
- the coupling fork.
Adjust the value L = 107.7
-0.5
mm.
Tighten the lock nut E on the coupling fork.
Mount the servobrake on the vehicle.
Purge the braking circuit.
RETAINER VALVE REPLACEMENT
The operation is performed without
dismounting the servobrake off the vehicle.
DISMOUNTING
Disconnect the connection of the air suc-
tion hose with the servobrake retainer valve.
Dismount the valve by rotating and then
pulling it.
Dismount the retainer valve gasket.
REMOUNTING
Check the state of the retainer valve gasket
and replace it if necessary.
Mount the new retainer valve gasket.
Attach and mount the new retainer valve.
Connect the air suction hose.
Air filter – servobrake retainer valve
A
F
E
THE MECHANICAL ELEMENTS CONTROLS
37
37 - 7
Handbrake - adjustment
The adjustment of the handbrake shall be performed with the vehicle lift on a two-column
elevator.
Note :
The adjustment is obligatory performed anytime the brake shoes or secondary cables
have been replaced.
Release the control lever of the hand brake (release position)
Tighten the nut (1) until the shoes lining come lightly into contact with the brake drum.
The adjustment shall be performed so that is insuring a hand brake lever stroke of min.12
teeth until the blocking of the wheels.
Lower the vehicle from the elevator.
THE MECHANICAL ELEMENTS CONTROLS
37
37 - 8
Handbrake control lever
TIGHTENING MOMENTS (daNm)
Attachment screws of the handbrake lever on central floor 1.2
DISMOUNTIN
G
Disconnect the battery.
Release the hand brake control lever ( released position).
Lift the vehicle by means of a two columns elevator;
Detach the rudder bar fork (5) from the end rod (3) by unscrewing the lock nut (1) and
remove the ball-ended washer (2).
Remove the secondary cables ends from rudder bar seats.
Detach from clips the rod (3) from rudder bar (4)
Lower the vehicle from the elevator and inside the vehicle dismount:
- seat;
- carpet attachment clips in the rear side area
- inner attachment of the left/right middle pillars coverings.
Move the front seats backwards and dismount the attachment screw (6) of the handbrake
control on the central floor.
3
4
5
2
1
THE MECHANICAL ELEMENTS CONTROLS
37
37 - 9
Move the seats ahead and dismount:
- safety belts lower attachment screws;
- attachment screws of the front safety
belts locks and remove them.
Clear the cockpit carpet towards front seats.
Dismount the handbrake control attachment
screw (7) on the central floor.
Remove the upper casing of the handbrake
(8).
Handbrake control lever
Disconnect handbrake contact (9).
Take off the assembly handbrake.
RE MOUNTING
Grease the shafts with UM 185 Li 2M
grease.
Perform the dismounting operations in the
reverse order, taking care to apply a sealant
material layer on the outline of lower casing of
the handbrake lever assembly.
Readjust the handbrake.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст