Dacia Solenza (engine E7J). Service manual — part 129
74
REAR TABLE
74 - 1
Lateral table
DISMOUNTING
Release the table cord from button (3)
that is attached on the hatchback by means
of the screw (2) and the nut (4).
Extract the panel (1).
Release the rear table (1) from the lateral
supports channel.
Disconnect the battery.
Disconnect the rear speaker connector.
Dismount the attachment screws of the
rear bench on its supports.
Recline the bench backrest.
Dismount:
-
screw (8) from the maintaining clip (7)
attaching the table lateral support on the lat-
eral frame lining;
-
screws (5) from maintaining clips (6)
attaching the table lateral support on the
bench support.
Detach from clips, the table lateral sup-
port (9), from rear quarter panel trim.
Dismount the speaker from the table lat-
eral support.
REMOUNTING
Perform the dismounting operations in
the reverse order.
Attention !
The speaker is to be mounted with the
connector towards vehicle’s front part.
Check the operation of the rear speaker.
1
9
8
4
3
2
7
6
5
REAR TABLE
74
74 - 2
DISMOUNTING
Dismount the rear plate.
Dismount by measn of a screwdriver, in
the arrow direction, the table pivot.
In case head of the pivot, its remaining is
inserted inside the metallic rod of the table by
means of a screwdriver and a hammer, as per
bellow presented drawing.
REMOUNTING
Perform the dismounting operations in
the reverse order.
PIVOT
Lateral table
74
REAR TABLE
74 - 3
REAR PLATE BUFFER
DSIMOUNTING
Push the rear plate buffer by means of
a screwdriver according to the bellow
presented drawing
REMOUNTING
Perform the dismounting operations in
the reverse order.
REAR PLATE CORD
DISMOUNTING
Dismount
- rear table,
- the agraffe of the rear plate cord
together with its cord as per bellow presented
drawing.
REMOUNTING
Perform the dismounting operations in the
reverse order.
Lateral table
75
75 - 1
FRONT SEATS SLIDES GUIDES
Front seat
75 010
TIGHTENING MOMENTS(daNm)
Front seat attachment screws 2,1
DISMOUNTING
Dismount the attachment screws (1) of the
front seat on the side and central cross mem-
ber in the front part.
By acting upon the lever (2) in the arrow
direction, bring the seat in front position and
dismount the attachment screws (3) of the front
seat on the side and rear cross-beam in the
rear part.
1
2
3
4
5
Release the front chair.
Remove the headrests by simultaneously
pushing of the buttons (4) attached on the head-
rests sleeves.
REMOUNTING
Perform the dismounting operations in the
reverse order.
The front seat attachment screws are to be
tighten to the required moment of 2,1 daNm.
ADJUSTMENTS
The front seats, have two possibilities of ad-
justment:
- front or rear longitudinal movement,
which can be performed by lever’s operation
(2);
- seat back reclining up to the horizontal
position, by rotating the round button (5).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст