Dacia SuperNova (engine E7J). Service manual — part 18
ENGINE E7J-A-2/60
12
FUEL MIXTURE
D
ISMO UNTING
The battery is disconnected.
The air tube is taken off the battery-protecting screen.
The four screws (1) for air-filter fixing are taken off.
The hose connecting the combustion-head cap and the air-filter is disconnected.
The air-filter is taken apart
To disconnect:
-the acceleration cable (the end of the cable is uncoupled from the command lever
of the clapper, and then it is taken off the sleeve on the stand);
-the connectors:
I. of the step-by-step engine; II. of the clapper potentiometer.
R
E
-M
O UNTING
The fitting of the clapper body is replaced;
The same steps are taken as in the case of the dismantling, only in the reverse order.
12 - 4
1
I
II
CLAPPER BODY
(no. 2 clamp is pulled upwards and the connector is taken off)
The command lever is uncoupled off the body of the clapper;
The clapper body is taken apart.
2
2
ENGINE E7J-A-2/60
12
FUEL MIXTURE
The following are taken apart:
- air-filter;
- acceleration cable;
- injection ramp (see Chapter Injec-
tion ramp);
The electric connectors are uncoupled:
- atmospheric pressure sensor;
- air temperature sensor;
- step-by-step engine;
- clapper potentiometer.
The fuel supply conduits are taken apart (both going- and return);
The clapper command lever is uncoupled and the body of the clapper is taken off;
The screws and screw-nuts fixing the intake collector are taken apart.
R
E
-M
O UNTING
The fittings of the intake collector are replaced;
The same steps are taken as in the case of the dismantling, only in the reverse order.
Tighten the inlet manifold screws and nuts at the required moment of 2.5 daNm.
T
IGH TENING
CO UPLE
(daNm)
Screws and screw-nuts for intake collector 2.5
INTAKE COLLECTOR
12 - 5
D
ISMOUNTING
ENGINE E7J-A-2/60
12
FUEL MIXTURE
T
IGH TENING
CO UPLE
(daNm)
Screws for collector fixing 2.5
D
ISMO UNTING
The thermic screen is taken apart;
The connection between the exhaust collector and the exhaust pipe is taken off;
The exhaust collector is taken apart
Re-mounting
The same steps are taken as in the case of the dismantling, only in the reverse order.
The screws are tightened at the couple.
EXHAUST COLLECTOR
12 - 6
E7J-A-2/60 ENGINE
13
PUMP SUPPLY
A
IM
:
To avoid accidental fires owing to fuel leaks, which can be caused by an accident.
F
UNCTIONING
:
The shock-sensor lies in the engine compartment: it is mounted on the left-side shock-
absorber column.
During a shock, the ball of the sensor goes out of its slot, and thus achieves the breaking
of the electric circuit between the relay commanding the petrol-pump and the petrol-pump
itself.
P
LACING
BACK
TH E
SH OCK
-
SENSOR
IN
O PERATIONAL
MO DE
In order to resume the functioning of the shock-sensor it will suffice to press its top,
and thus replace the ball in its former position.
BREAKING FUEL SUPPLY
13 - 1
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст