Dacia SuperNova (engine E7J). Service manual — part 130
82B
HORN - ENGINE IMMOBILISER
82B - 53
The engine hood connector is dismounted as follows:
- easy pull the blocking clip of the wiring connector and then disconnect the engine hood contact;
- press the blocking clips of the lateral sides of the contact;
- push upward the contact in order to remove it from its place.
Mount the new contact in its support by downward pushing, until a “click” is heard, confirming
the correct connecting.
Connect the wires connector to the contact of the hood.
Check the proper operation of the hood contact and of the anti intrusion system.
DISMOUNTING – REMOUNTING OF THE HOOD CONTACT
82B
HORN - ENGINE IMMOBILISER
82B - 54
NOTE
If the dismounting / remounting of the front doors or hatchback contacts,
check after that, the correct operation of the anti intrusion system.
LEFT SIDE VOLUME SENSOR REPLACEMENT
If sensor replacement is required, proceed as follows:
- take out carefully the sensor from its support by detaching from clips;
- dismount the attachment screw of the sensor support on the front left pillar upholstery.
- dismount the three attachment screws of the upper upholstery of the front left pillar and
carefully remove the upholstery;
- carefully disconnect the sensor connector from the vehicle’s wiring;
- mount the new volume sensor and its support performing the above mentioned operations
in reverse order, and then checking the proper operation of the anti intrusion system.
ATTENTION
Be sure that the volume sensor mounted on the left side has marked the
letter “T” on the red colour collar.
Mount the volume sensor in such way, to be oriented towards the back of the vehicle,
parallel with the side windows.
RIGHT SIDE VOLUME SENSOR REPLACEMENT
If sensor replacement is required, proceed as follows:
- take out carefully the sensor from its support by detaching from clips;
- dismount the attachment screw of the sensor support on the front right pillar upholstery.
- dismount the three attachment screws of the upper upholstery of the front right pillar and
carefully remove the upholstery;
- carefully disconnect the sensor connector from the vehicle’s wiring;
- mount the new volume sensor and its support performing the above mentioned operations
in reverse order, and then checking the proper operation of the anti intrusion system.
ATTENTION
Be sure that the volume sensor mounted on the right side has marked the letter
“R” on the white colour collar.
Mount the volume sensor in such way, to be oriented towards the back of the vehicle,
parallel with the side windows.
VOLUME SENSOR DISMOUNTING – REMOUNTING
83
INSTRUMENT PANEL
INSTRUMENT PANEL ( until 01.06.2001)
A . INSTRUMENT PANEL – CONNECTORS DISPOSAL
( until 01.06.2001)
83-1
A
C
B
D
83
INSTRUMENT PANEL
CONNECTOR C
1. Instrument panel lighting
2. Ground
3. Anti starting indicator
4. Supply (+ IC)
5. Free
6. Injection failure indicator
CONNECTOR D
1. Battery charging circuit failure indicator
2. Fuel minimum level warning
3. Free
4. Free
5. Free
6. Free
7. Free
8. Free
83-2
The correspondence between the positions from A,B,C,D connectors of the instrument panel
and the components of the vehicle electric equipment is the following :
CONNECTOR A
1. Free
2. Rear window defrosting indicator
3. RPM
4. Cooling fluid temperature indicator
5. Oil pressure warning
6. Cooling fluid temperature warning
7. Left turning indicator
8. Left turning indicator
9. Hazard lights indicator
10. Instrument panel ground
CONNECTOR B
1. High beam indicator
2. Free
3. Free
4. Right turning indicator
5. Right turning indicator
6. Supply ()+DC)- after contact
7. Hand brake, braking system failure warning
8. Brake pads wear indicator
9. Free
CONNECTORS ( until 01.06.2001)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст