Dacia SuperNova (engine E7J). Service manual — part 58
DRIVE SHAFTS
29
BELLOWS TO WHEEL
Catch the steering knuckle casing in a vice
with soft jaws.
Put the spring and head in the tripod
groove.
Brings the clogs to the center.
Position the retaining star (s), and each of
its arms, being at the bisecting lines of the
angles formed by the tripod arms.
Introduce the transmission shaft in the
steering knuckle casing, positioning it, subject
to the marks (the three clogs penetrating in
the three rolling routes of the shaft).
Slide slowly the transmission shaft, in
order to engage one arm of the retaining star
in the marked point of the transmission shaft,
and press it for correct centering.
Placing the other retaining star two arms,
it will be made easy by a screwdriver, with its
end modified as per drawing:
A = 5 mm B = 3 mm
Ensure that retaining star arms are correctly
positioned in the shaft marks.
Check by hand, the joint operation.
Must not exist any hard point.
Distribute in the bellows and in the steering
knuckle casing the grease prescribed dosage.
NOTE
It is obligatory to observe the quantity and
type of the prescribed grease, 2 l +1 cl, ELF
CARDREXA RNT 2.
29 - 10
Left
transmission
S
DRIVE SHAFTS
29
BELLOWS TO WHEEL
Position the two bellows beads in the grooves of the steering knuckle casing,
consequently on the transmission shaft tube.
Place a non-cutting, round headed rod between the transmission shaft and the bellows
in order to dose the amount of air inside.
Mount the two collars, by means of the two rods used also at the dismounting operation.
29 - 11
Left
transmission
DRIVE SHAFTS
29
BELLOWS TO GEARBOX
JOINT TOWARDS GEARBOX - GI
1. Tulip
2. Tripod
3. Blocking ring
4. Rubber bellows
5. Maintaining collars
DISMOUNTING
Cut the maintaining collar.
Cut by means of a saw the existent collar,
taking care not to scratch the tulip in the
mounting area with the bellows.
29 - 12
Right
transmissi
on
DRIVE SHAFTS
29
Cut the bellows.
Remove maximum of grease.
NOTE :
The tulip not being equipped with a
hood having retainin g wings,
dismounting is to be performed without
forcing.
It is avoided the cams exit from the
trunnions (tripod arms) because the roll-
needles and the cams are paired and must
be not reversed.
Never use thinner to wash the
component parts.
Dismount the blocking ring.
BELLOWS TO GEARBOX
29 - 13
Right
transmissi
on
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст