Dacia SuperNova (engine E7J). Service manual — part 105
AIR CONDITIONING
62
62 - 13
Defective cooling
Is climate blower working ?
Check the blower fus
e and rel
ay.
Are they defective?
Supply the blower motor
at (+12 V).
Does it works?
Replace the climate control
switch or repair the electric
circuit.
Replace them
No
Yes
Yes
Change
blower.
No
No
Adequate air flow ?
Check the airflow flaps
operation and the air ducts
integrity.
Compressor belt tensioning is good?
Yes
Yes
No
Any refrigeran
t fluid leakage
in the system ?
No
Yes
Yes
Is compressor clutch supplied with (+ 12 V)?
No
Yes
No
Clutch is coupling the
compressor?
Replace the thermostatic
expansion valve.
Yes
No
Check the electric circuit
for supplying and control.
Detect the refrigerant fluid
leakage cause . Perform refilling.
Pressure controller is working?
Replace it.
Refacei tensiunea curelei
Replace it.
No
Yes
DIAGNOSIS
AIR CONDITIONING
62
62 - 14
Correct AC system filling.
Compressor does not work.
Yes
Yes
No
Yes
Check the clutch coil. Damaged,
short-circuit?
Replace the
compressor.
Restore the electric circuit
between E and clutch.
Is + 12 V at pole E5 of E relay?
Is + 12 V at pole E3 of E relay?
Is + 12 V at pole E3 of E relay?
Check fuse S6 from engine
compartment. Restore the
wiring between S6 and relay E.
No
Restore the wiring between pole
E1 of E relay and pole D5 of D
relay.
No
The wiring between injection computer
and the pole E2 of E relay is broken ?
Yes
Repair the wiring.
Yes
No
Check the pressure
controller electric circuit.
Injection computer does not receive
AC actuation?
Yes
Check the switch electric circuit.
Pressure controller is working?
No
Replace the switch.
AC control switch is
working ?
No
Yes
Yes
Check the pressure controller
electric circuit.
No
Replace the pressure controller.
No
DIAGNOSIS
SEALING OPENING ELEMENTS
65
65 - 1
DOOR FRAMES GASKETS
DISMOUNTING
Dismount the front and rear frames gaskets following the doors outliners, by drawing towards
outside of one of their ends.
REMOUNTING
Perform in the reverse order the dismounting operations.
The mounting of the sealing gaskets on frames is performed by tapping with a rubber hammer.
CARRIAGE BODY SEALING
SEALING WINDOWS AND SCREENS
66
66 - 1
1. Windscreen gasket
2. Hatchback gasket
3. Fix window gasket
DISMOUNTING
Dismount the windscreen glass (1), hatchback (2), or fix (3), together with the gasket by
pushing from the inside of the vehicle.
The glass gasket shall be cleaned is reused, or replaced with a new one.
REMOUNTING
Position the gasket (2) around the glass (1) and place the assembly on a protection plate.
Place the gasket (2) all around the glass (1) where a cotton cord of 3 – 4 mm diameter has
been previously introduced, leaving at the ends (3) about 20 mm of cord, and between the ends,
the distance shall be not more than 10 mm.
GLASSES SEALING
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст