Dacia Pick-Up 1304/1305/1307. Service manual — part 129
80
80 - 4
BATTERY - FRONT HEADLIGHTS
The charging currents of the batteries are showed in the following table:
If after battery charging the density is higher, add distilled water, and if it is lower add
electrolyte with 1,40 g / cm≈ density, observing that the electrolyte level to be 10 – 15 mm
over the separators. In case of adding water or electrolyte, the battery shall be submitted to
a homogenization charging process, in the second stage II, during 15 – 20 min.
The total charging time of these types of batteries is of about 35 hours.
The dry-charged batteries shall be filled with electrolyte with 1,28 g/cm≈ density at
20 ° C, until the level of the latter is 10 – 15 mm over the separators. After 2 – 3 hours,
during which the electrolyte penetrates the plates, check again the level the level and refill
it with electrolyte of same density, then batteries can be put it in operation. This type of
batteries are submitted to a charging processus, by mean of a voltage rectifier having the
charging current value set in second stage II, in the follow situations: batteries stored for
more than 6 months from the manufacturing date; extremely heavy exploitation conditions
(repeated startings at low temperatures).
After finishing the charging process, screw the battery plugs, taking care not to obturate
the plugs vents, the surface of the battery to be dry and clean and the terminals greased
with neutral grease, acid resistant.
T
YPE
O F
BATTERY
N
O MINAL
VO LTAG E
C
H ARG ING
CURRENT
[ V ]
I
I
[ A ] I
II
[ A ]
12 V - 45 Ah
12
4,5
2,25
12 V - 55 Ah
12
5,5
2,75
12 V - 66 Ah
12
6,6
3,3
12 V - 70 Ah
12
7,0
3,5
BATTERY
80
BATTERY - FRONT HEADLIGHTS
80 - 5
D
ISMO UNTING
Disconnect the battery.
Take out the headlight corrector attachment clip (B).
Unscrew the headlight corrector control screw (C).
Disconnect the headlight and signaling lamp connectors.
Push the headlight forward.
R
EMOUNTING
Place by pressing the adjustment screws in the headlight seats (by pushing towards the
engine compartment of the headlight).
Mount the headlight corrector control screw (C).
Insure the headlight by means of the attachment clip (B).
Connect the battery and adjust the headlights.
HEADLIGHT BULBS REPLACEMENT
80
80 - 6
BATTERY - FRONT HEADLIGHTS
HEADLIGHT BULB REPLACEMENT
D
ISMO UNTING
Disconnect the connector (1).
Take out the protector (2).
Release the springs sustaining the bulb.
Replace the bulb.
R
EMO UNTING
Perform the dismounting operations in the reverse order.
NOTE:
After headlight or bulb replacement it is recommended the adjustment checking.
FRONT SIGNALING BULB REPLACEMENT
Disconnect the wires from the signaling lamp.
Rotate the lamp-holder (3) and then remove it (draw it).
Replace the bulb.
Place the lamp-holder (3) in the signaling lamp and fix it by rotation.
LAMPS
80
BATTERY - FRONT HEADLIGHTS
80 - 7
BULBS
LAMPS
BULBS
Headlights
Front parking, side signaling lamp, trunk
lighting
Front turn signal lamps
Fog projectors
Stop, parking
Rear lampe
Turn signal and back-up
Rear fog lamp
License plate lamps, courtesy lamp, glove
box lamp
Instruments panel lighting and warnings
Two phases bulb R2 - 12 V - 40/45 W, holder
with flange P 45 t 41.
Bulb 12 V - 4W with holder B A9 s.
Bulb 12 V - 2 1W (colored) with holder BAU 15 s.
Halogen bulb H3; 12 V - 55 W with holder
P 16225.
Bulb12 V - 21/5 W with holder B AY 15 d.
Bulb 12 V - 21W with holder BA 15 s.
Bulb 12 V - 21W with holder BA 15 s.
Bulb SOFIT 10x35 type AS02; 12V - 5W
wholder Sv 8,5
Bulb 12 V -1,2W
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст