Dacia Pick-Up 1304/1305/1307. Service manual — part 138
85
WINDSCREEN WIPERS
85 - 1
The windscreen wiper mechanism which is equipping the DACIA pick-ups and its
components may be seen in the following detailed drawing.
Subject to the type of dashboard which the DACIA pick-ups are equipped with
(restyled dashboard or dash board type CN) the mechanism dismounting shall be perform
differently.
According to the type of the vehicle equipment , with or without windscreen wiper timer, the
windscreen wiper is connected to its wiring as per following diagrams:
a ) with windscreen wiper timer.
b) without windscreen wiper timer.
On these diagrams the following elements may be identified:
1. Windscreen wiper motor
2. Right connection plate (+ DC )
3. Windscreen wiper washer pump
4. Washer – wiper switch
5. Windscreen wiper timer
WINDSCREEN WIPER MECHANISM
WINDSCREEN WIPERS
85
85 - 2
VEHICLE WITH DASH BOARD TYPE 1325
D
ISMO UNTING
Disconnect the battery.
Dismount the attachment nuts of the windscreen wiper arms and the blades.
Unscrew the attachment nuts of the shafts on the lower frame of the windscreen, recover the
rubber washers and bushings.
Dismount the dashboard.
Disconnect the wiring connector from the windscreen wiper drive motor.
Unscrew the attachment screws of the mechanism on the plate.
Draw the mechanism backwards and then take it out from the right side of the steering wheel.
R
EMOUNTING
Perform the dismounting operations in the reverse order.
NOTE: When mounting the windscreen wiper arms, the wiper drive engine must
be in position “stop at fixe point “.
WINDSCREEN WIPER MECHANISM
85
WINDSCREEN WIPERS
85 - 3
WINDSCREEN WIPER MECHANISM
WINDSCREEN WIPER DRIVE SHAFT REPAIR
This operation shall be performed for Dacia vehicles, as per the following drawing, after
dismounting the mechanism from the vehicle.
D
ISMO UNTING
Disconnect the auxiliary connecting rods (A) and (B) off the shafts.
Dismount the shafts (1) off the mechanism support (2).
Depress the grooved bushing.
Dismount the shaft; recover the bushing and the rubber gaskets.
R
EMO UNTING
Check the state of the rubber gaskets.
Clean the parts to be free of oxides.
Grease the parts with grease Li Ca Pb type II.
Remount :the rubber gasket on the shaft, the rubber gasket shaft and the bushing.
Press the grooved bushing.
Mount the shafts on the mechanism support.
Grease the joints with grease type II Li Ca Pb and couple the auxiliary connecting rods on
the shafts (A) and (B).
A
B
1
2
WINDSCREEN WIPERS
85
85 - 4
D
ISMO UNTING
Unscrew the attachment nut of the control auxiliary connecting rod, ( B ) on the drive motor shaft.
Unscrew the attachment screws of the drive motor on the mechanism support.
R
EMOUNTING
Perform the dismounting operations in reverse order.
NOTE: When remounting, the auxiliary connecting rods A and B shall be
aligned, the drive motor being “stopped at fix position”.
WINDSCREEN WIPER DRIVE MOTOR REPAIRING
Windscreen drive motor ( components parts drawing ).
D
ISMO UNTING
Dismount the windscreen wiper drive motor off the mechanism support.
1. Reduction gear dismounting :
- unscrew the attachment screws of the cap (B);
The operation shall be performed after dismounting the mechanism off the vehicle.
WINDSCREEN WIPER DRIVE MOTOR
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст