Dacia Pick-Up 1304/1305/1307. Service manual — part 134
INSTRUMENT PANEL
83
83 - 8
PRESENTATION
This function is activated after switch on the ignition contact (engine starting) and is warning if
the driver has not fasten its safety belt, by means of the safety belts warning light, located on the
central dashboard.
OPERATING DIAGRAM
The following components elements may be identified:
1
. Safety belts warning light board lamps
2
. Safety belts contacts
3
. Right connection plate ( + DC )
4
. Mass ( at hand brake attachment )
As it can be seen from this diagram, when the ignition contact is on, the warning light (1) shall
be lighted if the safety belt is not fasten, and after driver fasten its safety belt, the warning light
must turn off, confirming the correct attachment of the safety belt.
FASTEN SAFETY BELTS WARNING LIGHT
83
INSTRUMENT PANEL
83 - 9
D
ISMO UNTING
Disconnect the battery.
Disconnect the speedometer cable from the dash board.
Disconnect the connectors and the speedometer cable.
Dismount the half housings of the steering wheel.
Dismount the headlight adjustment control.
Dismount the screws that attach the instrument frame.
Release the two side attachment clips that attach the instrument panel on the dashboard.
Take out the instruments panel.
R
EMOUNTING
Perform in reverse order the dismounting operations.
VEHICLE WITH DASHBOARD TYPE 1325 REPLACEMENT
INSTRUMENT PANEL
83
83 - 10
OIL PRESSURE WARNING LIGHT STILL ON AFTER
ENGINE STARTING
Check the oil pressure.
The pressure is not correct; there is
a failure in the oil circuit.
The pressure is correct;
replace the oil pressure switch.
OIL PRESURE WARNING LIGHT IS NOT ON WHEN CONTACT
SWITCH ON
Place the wire from the oil pressure switch
to the mass.
Warning light is on; replace the oil pressure
switch.
Warning light is not on.
Bulb is not burnt;check the bulb
supply wiring and repair it.
Burnt bulb; replace the bulb.
Check if the bulb is not burnt.
DIAGNOSTIC
83
INSTRUMENT PANEL
83 - 11
FUEL LEVEL INDICATOR SHOWING ALWAYS FULL
Disconnect the connection wire to the
probe.
The indicator comes back to zero;
replace the probe.
Yes. Repair the wiring.
The indicator does not come to zero;
Is there any mass short-circuit of the
connection wire to the probe?
No. Replace the indicator.
FUEL LEVEL INDICATOR NOT SHOWING CORRECTLY
Disconnect the connection wire to the
probe.
The indicator does not come to zero;
check possibility of a mass short-
circuit of the connection wire to the
probe.
There is not short-circuit;
The indicator is defect.
The indicator comes back to zero.
Place at the mass the wire
connection to the probe.
The indicator does not show full;
the probe connection wire is not
connected or broken.
The indicator is showing full;
Replace the probe.
There is a short-
circuit; Repair
the wiring.
DIAGNOSTIC
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст