Dacia Pick-Up 1304/1305/1307. Service manual — part 101
40
GENERAL
40 - 11
During the vehicle exploitation, the body may suffer different distortions, that lead many times
to the wheels setting angles change, body elements breakage, vibrations or even mechanical
parts wear.
In these conditions, before performing the vehicle body reparation, some checking is
necessary:
Visual checking - consisting in the examination of the mechanics elements attachments
and of the distortions that occur in the damaged areas.
Checking with the bar (control gauge) – consisting in comparing the measurements
done in symmetric points.
CHECKING OF THE LONGITUDINAL GIRDERS POSITION
The checking of the longitudinal girders position consist in comparing the measurements
done on symmetric points.
The checking of B – B’ , H – H’ points is affecting the mechanical part of the half-front
axles and of the rear axle. Certainly, the distances between the points must be equal, as
follows: BB’ = HH’.
The checking of A,F,F’ , A’ points is affecting the centering of removable parts of the
body.
The distances between the points must be equals, as follows: AF = A’F’.
COLLISION DIAGNOSIS
40
GENERAL
40 - 12
COLLISION DIAGNOSIS
CHECKING WITH THE BAR GAUGE
CENTRAL PART CHECKING
It is performed in the purpose to establish if one of the distortions is not affecting this
part, from which the checking starts.
The checking points are : Holes A – F – F’ – A’ and consequently H – H’ and B – B’.
FRONT LONGITUDINAL GIRDERS CHECKING
Checking points are: B – B’ for lower longitudinal girders and G – G’ for upper
longitudinal girders.
Lower longitudinal girders:
Compare the diagonal distance A – B’ with
diagonal A’ – B.
Upper longitudinal girders:
Compare the diagonal distance F – G’ with
the diagonal F’ – G .
H
F’
40
GENERAL
40 - 13
COLLISION DIAGNOSIS
REAR LONGITUDINAL GIRDERS CHECKING
The checking points are C – C’ , H – H’, D – D’ and E – E’. Compare the A’ – H
diagonals, continuos line with A – H’ diagonal broken line and the A’ – C diagonal
continuos line with A – C’ diagonal broken line.
These four holes being closest to the rear axle, must be first checked. Compare diagonals
H’ – D and H’ – E continuos line with diagonals H – D’ and H – E’ straight line.
FLOOR FRAME CHECKING
NOTE: The values marked * are for Dacia 1307.
40
GENERAL
40 - 14
BODY CHECKING/ STRAIGHTENING BENCH
TYPE CELETTE
For checking, straightening or repairing the DACIA vehicles bodies, the use of the
CELLETTE bench is recommended.
The checking / straightening bench type CELETTE ( service code CAR 500 ) is
composed of:
-CAR 501 ( 1 mobile bench with four wheels, four parts for vehicle anchoring, one
traction arm of 10 t, type “ CAIMAN “).
-CAR 502 - set modular cross bars;
-CAR 503 - 22 towers MZ;
-CAR 504 - set accessories for traction;
-CAR 505 - set of specific supports for DACIA Bl, Bk.;
-CAR 506 - set of specific supports for DACIA 1304, 1307 CAR 507 - set of
specific supports forDACIA NOVA.
1. CAR 501
The mobile bench (1) is provided with four anchoring parts (2) - (fig 1), which can be
used when a body checking / straightening operation is performed.
1
2
( fig.1 )
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст