Dacia Pick-Up 1304/1305/1307. Service manual — part 111
52
NON SIDE OPENING ELEMENTS MECHANISMS
D
ISMO UNTING
Release the cable of front hood (1) from the connection with lock (3) and take out by
lock hook rod (4).
Dismount the attachment front hood lock nuts (2).
R
EMO UNTING
Perform in the reverse order the dismounting operations.
FRONT HOOD LOCK
52 - 1
3
2
1
4
NON SIDE OPENING ELEMENTS MECHANISMS
52
D
ISMO UNTING
To dismount the rear drop side lock (1) unscrew the screws (2) of the closing hook
(3) and the screws (4) of the assembled lock (5).
52 - 2
REAR DROP SIDE LOCKING SYSTEM DACIA 1304 Pk, 1307
R
EMO UNTING
Perform in the reverse order the dismounting operations.
1
4
3
2
REAR DROP SIDE LOCKING SYSTEM
52
NON SIDE OPENING ELEMENTS MECHANISMS
R
EMO UNTING
Perform the dismounting operations in the reverse order.
52 - 3
D
ISMO UNTING
Dismount :
- the screws (1) and (2) of the end of the stopper chain (3);
- the lock attachment screws (4) of the side panel the lock attachment screws (5)
of the rear drop side panel.
REAR DROP SIDE LOCKING SYSTEM DACIA 1304 platform
5
4
1
2
3
REAR DROP SIDE LOCKING SYSTEM
54
WINDOWS
WINDSCREEN AND CAB REAR WINDOW
The replacement of these windows is performed in case they are broken, when they are
not according to the required overall dimensions or have manufacturing defects (image
distortions,cracks, etc).
DISMOUNTING OF A BROKEN WINDOW
If the window or part of it did not fall, the window gasket shall be dismounted and the
pieces of broken window shall be removed from it easier by sticking a sheet of paper on
each surface.
PREPARING FOR MOUNTING
Position the gasket (2) around the
window (1) and place the assembly on a
protection plate.
Place in the gasket channel all around
the gasket frame; a cotton cord (4) of
3 – 4 mm diameter, so that at its ends (3)
to have some more 20 cm of cord, and
between the ends , the distance shall not
be more than 10 cm.
MOUNTING OF WINDSCREEN AND REAR WINDOW
The windscreen – gasket – cord assembly
is placed on the frame, for mounting, so
that the cord ends are placed towards the
inside of carriage body.
54 - 1
From the inside of the vehicle, successively draw the ends of the cord, beginning with
the lower parts, in this way the window gasket edge is lifted and then lowered on the
frame. At the outside , the window gasket is seated by slightly pressing it on window, so
that the tightening is uniform on the whole windscreen contour and frame.
The cord is always removed through the upper part of the windscreen.
Each time a windscreen or rear window is mounted, ensure the uniform setting of the
whole assembly on the carriage body by tapping several times with a rubber hammer, on
the edge of the window frame.
1
4
3
2
WINDOWS
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст