Dacia Pick-Up 1304/1305/1307. Service manual — part 32
STARTING AND CHARGING
16
16 - 20
1
2
3
4
TYPE OF STARTER
2146
MAXIMUM POWER
995 W ( 1,35 CP )
NOMINAL VOLTAGE
12V
MINIMUM STARTING ROTATION
150 tr./ min.
Number of te eth
9
Module
2,116 / 1,1814
Pressure angle
12
0
Voltage ( Us )
9,5 +/- 0,5 V
Intensity ( Is )
200 A
Coupling ( Cs )
0,5 daNm
Minimum rpm ( n min s )
1400 rot. / min.
Voltage ( Ub )
7,5 V
Coupling ( Cb )
0,95 daNm
Absorption current ( Ia )
425 A
PINION
CHARACTERISTICS
CHARACTERISTICS
IN LOAD
BLOCKED COUPLING
(bendix to be blocked)
The starter is an engine of continuos current with serial excitation provided with a rolls idle
running mechanism and gearing commended by side electromagnet.
A. ELECTRIC DIAGRAM OF THE STARTER TYPE 2146
1
. Battery
2
. Contact switch
3
. Starter solenoid
4
. Starter rotor and stator
STARTER
16
STARTING AND CHARGING
16 - 21
Characteristics of load at the temperature of 20
0
+/- 5
0
C
. Average curves:
Test must not be done more than 4 – 5 seconds To lay out these characteristics measure
the absorbed current, supply voltage,RPM and coupling.
B. ELECTRIC DIAGRAM OF THE 2600 TYPE STARTER
The starter type 2600 is an engine of continuos current with excitation by constant
magnets having a coupling mechanism with rolls and gearing commended by side
electromagnet.
1
. Battery
2
. Contact switch
3
. Starter solenoid
4
. Starter rotor and magnets
Characteristics of load at temperature of 23
0
+/- 5
0
C
. Minimal curves.
1
2
3
4
STARTER
STARTING AND CHARGING
16
16 - 22
Test must not be done more than 4 – 5 seconds To lay out these characteristics measure
the absorbed current, supply voltage,RPM and coupling.
STARTER
STARTER
16
STARTING AND CHARGING
16 - 23
D
ISMO UNTING
Disconnect: battery, starter supply cable,supply wire of the coupling relay.
Dismount: air filter, starter protection screen, and the three screws, which attach the
starter to the clutch housing.
Detach the starter let its end down until comes into contact with the exhaust pipe, rotate
the starter by 90° and take it out.
R
EMOUNTING
Place the starter with its end up; lower it until it comes in contact with the engine
support. Rotate the starter by 90° until the end comes in contact with the exhaust pipe,
bring out the starter then place it in its seat.
Remount :
- attachment screws;
- supply wires;
- protection screen;
- air filter.
Reconnect the battery.
STARTER
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст