Dacia Pick-Up 1304/1305/1307. Service manual — part 70
FRONT BEARING ELEMENTS
31 - 4
31
ELASTIC BUSHING, UPPER ARM BALL JOINT
ELASTIC BUSHING REPLACEMENT
SPECIAL
TOO LS
:
D
ENO MINATION
C
O DE
Front axle support cross bar
PF 509
Ball joint extractor
PF 476
Dynamometric wrench
MOT 50
Dismount the upper arm of the suspension.
Dismount on a press the worn bushing,
using a rod with the outer diameter of
D = 26mm.
Press the new bushing. On pressing, observe
the value A = 6mm.
Mount the upper arm on the vehicle.
BALL JOINT REPLACEMENT
SPECIAL
TOO LS
:
D
ENO MINATION
C
O DE
Front axle support cross bar
PF 509
Ball joint extractor
PF 476
Dynamometric wrench
MOT 50
31
FRONT BEARING ELEMENTS
31 - 5
Lift the vehicle using a two columns
elevator.
Dismount the wheel, mounting the
PF 509 crossbar, between the lower arm
shaft and the shock absorber joint shaft.
Release the ball joint from the steering
knuckle by means of the PF 476 extractor.
Dismount the attachment screw of the
upper ball joint.
Dismount the ball joint.
Assemble the attachment screw of the
rod with the ball joint and place it on the
arm.
ELASTIC BUSHING,UPPER ARM BALL JOINT
Attach the ball joint to the arm by
replacing the rivets with screws, the latter
being mounted with the ends towards the
bellow.
Mount the caster rod.
Couple the ball joint and tighten it to
the required moment.
Dismount the cross bar PF 509.
Mount the wheel and take down the
vehicle from the elevator.
Check and adjust, if necessary :
- the caster angle;
- the camber angle;
- the steering box position;
- the parallelism and the wheels
alignment.
In case protection below is damaged, replace it with a new one.
FRONT BEARING ELEMENTS
31 - 6
31
LOWER ARM
SUSPENSION LOWER ARM
SPECIAL
TOO LS
:
D
ENO MINATION
C
O DE
Front axle support cross bar
PF 509
Ball joint extractor
PF 476
Dynamometric wrench
MOT 50
D
ISMO UNTING
Lift the vehicle on the elevator and dismount the wheel.
Release the lower suspension ball joint by means the PF 476 extractor
Dismount the elastic bushings of the rod stabilizer.
Slowly lower the stabilizer rod to enable the taking out of the shaft.
Unscrew the nut and take out the shaft.
Release the lower ball joint and dismount the arm.
31
FRONT BEARING ELEMENTS
31 - 7
R
EMO UNTING
Mount the lower ball joint in the steering knuckle and slightly tighten the nut.
Lift the half-front axle by means of a jack.
Position the arm, grease it with special MoS2 grease and mount it.
Mount the elastic bushings of the stabilizer rod.
Compress the front axle in the lock position of the elastic bushings, introducing the
PF 509 support cross bar between lower arm shaft and shock absorber shaft.
Tighten the following to the required moment :
- the lower ball joint nut;
- the lower arm shaft nut;
- the stabilizer rod elastic bushing nut.
Mount the wheel, take down the vehicle from the elevator and remove the PF 509 support
cross bar.
LOWER ARM
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст