SsangYong Rodius (2013 year). Service manual — part 95
01-4
1. COMPONENT LOCATOR
1) Front View
01-5
0000-00
No.
FUNCTION
No.
FUNCTION
1
HFM sensor
12
Intake manifold
2
Intake air duct
13
Connecting rod
3
Resonance flap
14
Exhaust manifold
4
Cylinder head cover
15
Crankshaft
5
Exhaust camshaft
16
Engine mounting
6
Intake camshaft
17
Starter
7
Cylinder head
18
Crankcase
8
Spark plug connector
19
Oil pump sprocket
9
Valve tappet
20
Oil strainer
10
Injector
21
Oil pan
11
Exhaust valve
22
Drain plug
Front View
▶
01-6
2) Side View
No.
FUNCTION
No.
FUNCTION
23
Camshaft adjuster
27
Oil pump drive chain
24
Cooling fan and viscous clutch
28
Oil return pipe
25
Piston
29
Timing chain
26
Flywheel of drive plate
01-7
0000-00
2. DESCRIPTION AND OPERATION
1) Cleanliness and Care
An automobile engine is a combination of many machined, honed, polished and lapped surfaces with
tolerances that are measured in the ten-thousandths of an inch. When any internal engine parts are
serviced, care and cleanliness are important. A liberal coating of engine oil should be applied to friction
areas during assembly, to protect and lubricate the surfaces on initial operation.
Proper cleaning and protection of machined surfaces and friction areas is part of the repair procedure.
This is considered standard shop practice even if not specifically stated.
Whenever valve train components are removed for service, they should be kept in order.
They should be installed in the same locations, and with the same mating surfaces, as when they were
removed. Battery cables should be disconnected before any major work is performed on the engine.
Failure to disconnect cables may result in damage to wire harness or other electrical parts.
2) On-Engine Service
Disconnect the negative battery cable before removing or installing any electrical unit, or when a
tool or equipment could easily come in contact with exposed electrical terminals.
Disconnecting this cable will help prevent personal injury and damage to the vehicle.
The ignition must also be in LOCK unless otherwise noted.
Notice Any time the air cleaner is removed, the intake opening
-
Any time the air cleaner is removed, the intake opening should be covered. This will protect
against accidental entrance of foreign material, which could follow the intake passage into the
cylinder and cause extensive damage when the engine is started.
-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст