SsangYong Korando III (2010 year). Service manual — part 156
03-56
16) Time Lag Power Window Control
When turning the ignition switch to ON position, the power window relay is turned ON.
The power window relay keeps ON for 30 seconds even when stopping the engine.
However, the power window relay is turned OFF when opening a front door.
When locking the door (activation of theft deterrent mode), the power window relay is
immediately turned OFF.
1.
2.
3.
17) Sleep Mode
If the driver door/passenger door/rear doors/tailgate lock switch is not changed for 6 seconds with all
driver door/passenger door/rear doors/tailgate closed, key removed, IGN1 and IGN2 OFF, the
vehicle enters into sleep mode for system power down.
If any of conditions in Step (1) is not satisfied, the System Wake-up mode is activated.
When output such as room lamp, key hole illumination, tail lamps and power window is activating or
all the doors keep closed for 30 seconds after door is unlocked for conditions in Step (1), the system
is in normal mode. Then, if there is no change within 6 seconds with all output conditions and ready
conditions released and all the doors closed, the sleep mode is activated.
When turning on the overhead room lamp switch, the overhead room lamps come on for 10 minutes
and go off, and the sleep mode is activated after 6 seconds.
When the coming home light OFF conditions are satisfied, the sleep mode is activated.
In this condition, when opening a door or inserting the ignition key into key hole, the sleep mode is
deactivated.
1.
2.
3.
4.
5.
6.
03-57
8710-01
18) Flasher (Blinking) Function
Turn signal lamp control
▶
When the BCM is received the multifunction switch signal, it operates the turn signal lamp
and interior buzzer with the intervals of 400 ms ON/400 ms OFF for 75 times/min.
The turn signal lamps are operational only when IGN1 is ON.
If the turn signal lamp is defective during its operation, the turn signal lamp blinks with the intervals of
300 ms ON/300 ms OFF for 100/min and the interior buzzer sounds with same interval.
Defective conditions by BCM: Open - below load of 3.0 A, Short - over load of 7.0 A (load means lamp
load here)
When turning ON the turn signal switch, the lamp blinks 3 times by the BCM. When turning OFF the
switch during the operation, the turn signal lamp blinks 3 times and goes off.
When turning OFF and then immediately ON the turn signal switch during auto blinking operation of 3
times, the turn signal lamp blinks additional 3 times.
When turning ON another turn signal switch during the operation, currently operated turn signal lamp
stops immediately and another turn signal lamp starts blinking.
1.
2.
3.
4.
5.
6.
7.
03-58
Right turn signal lamp control
▶
When the BCM is received the multifunction right turn signal lamp switch signal, it operates the right
turn signal lamp and interior buzzer with the intervals of 400 ms ON/400 ms OFF for 75 times/min.
When turning OFF the right turn signal switch during its operation, the turn signal lamp and buzzer
stop the operation.
The turn signal lamps are operational only when IGN1 is ON.
If the turn signal lamp is defective during its operation, the turn signal lamp blinks with the intervals of
300 ms ON/300 ms OFF for 100/min and the interior buzzer sounds with same interval.
Defective conditions by BCM: Open - below load of 3.0 A, Short - over load of 7.0 A (load means lamp
load here)
When turning ON the turn signal switch, the lamp blinks 3 times by the BCM. When turning OFF the
switch during the operation, the turn signal lamp blinks 3 times and goes off.
When turning OFF and then immediately ON the turn signal switch during auto blinking operation of 3
times, the turn signal lamp blinks additional 3 times.
When turning ON the left turn signal switch during the right turn signal lamp operation, the right turn
signal lamp stops immediately and the left turn signal lamp starts blinking.
1.
2.
3.
4.
5.
6.
7.
03-59
8710-01
Hazard flasher switch control
▶
When pressing the hazard flasher switch, the left/right turn signal lamps blink with the intervals of 400 ms
ON/400 ms OFF for 75/min and the interior buzzer sounds with same interval.
When pressing the hazard flasher switch again during its operation, the turn signal lamps and horn stop
the operation.
This function is available if the battery is connected (B+).
If the turn signal lamp is defective during its operation, the left turn signal lamp blinks with the interval of
300 ms ON/300 ms OFF (100/min) and the interior buzzer sounds with same interval.
The tolerance between left turn signal lamp and right turn signal lamp should be below 100 ms.
The hazard flasher has a priority over the turn signal lamp.
Priority of hazard flasher is as follows:
Seat belt reminder > Key reminder > Sunroof > Tail lamp > Hazard flasher > Turn signal lamp
1.
2.
3.
4.
5.
6.
7.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст