SsangYong Korando III (2010 year). Service manual — part 136
02-4
Make sure a connector is connected
securely. Loose connection results in
malfunction.
-
When disconnecting a connector equipped with
a lock, press it down to the direction in the below
figure.
-
When checking voltage or continuity of the
connector terminal with a circuit tester, connect
the tester probe to the terminal at the harness
side. For a sealed type connector, connect the
probe to the terminal through the hole in the
rubber cap of the wiring. Take care not to
damage the insulation of the wires. Insert the
probe until it contacts the terminal completely.
-
When inspecting the airbag system, make sure to use a diagnostic device, not a circuit tester.
02-5
8410-00
2. CHECKING CABLES AND WIRES
Check for loose connection or rust.
Check terminals and wires for corrosion due to electrolyte leakage.
Check terminals and wires for open circuit.
Check the wire insulation and coat for damage, cracks or deterioration.
Check if the conductive parts of the terminals do not contact with vehicle body or other metal parts.
Check that the grounding part has continuity with mounting bolts and vehicle body.
Check that wires are properly routed.
Make sure that wires are securely fixed to avoid contact with sharp body parts and high-temperature
parts, such as the exhaust manifold and exhaust pipes.
The rotating parts, such as fan pulley and fan belt, perturbative parts and wiring should be secured
tightly at regular intervals.
Secure the wiring between the fixed parts, such as the vehicle body, and vibrating parts, such as the
engine, after slackening it slightly to prevent it from being damaged.
-
-
-
-
-
-
-
-
-
-
02-6
ICM box
Interior fuse box
Fuse box in engine compartment
The fuse and relay boxes consist of three boxes: Integrated Control Module (ICM) box in which the
relays of rear wiper, rear fog lamp, mirror folding, ACC, IGN1 & 2, horn, tailgate, power outlet, shift lock
(A/T) are integrated, relay & fuse box in engine compartment and interior fuse box.
2. SYSTEM LAYOUT
1. OVERVIEW
02-7
8410-00
3. OPERATING PROCESS
1) Fuse Box In Engine Compartment
The relay & fuse box in engine compartment is located in the left side of the engine compartment. The
wiper relay, horn relay, fog lamp relay, tail lamp relay and PTC relay are included in the PCB. The B+
supply is provided through the ALT+ (A) line, not by an extra fuse.
Capacity and name of engine compartment fuse and relay
▶
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст