SsangYong Korando III (2010 year). Service manual — part 403
09-5
1452-01
2) Battery
Battery assembly
Clamp - Battery
Bolt
Cable assembly - Cable positive
Cable assembly - Battery ground
Bolt - Earth
Cap - Terminal
Connector - Battery
1.
2.
3.
5.
6.
8.
9.
10.
Nut
Nut
Cab - Earth
Box assembly - Battery sub
Fuse - MID 80A
Clamp - Battery cable
Grommet - Ring terminal
Grommet - Ring terminal
17.
18.
20.
21.
22.
23.
24.
25.
09-6
Item
How to check
DTC set value / Action
Output current
B terminal current
Rotor coil
resistance
L terminal voltage
3. INSPECTION
1) Alternator
Output Test
▶
Disconnect the cable connected to the B
terminal on the alternator. Connect one
end of the ammeter to the B terminal and
the other end to the cable connected to
the B terminal.
Measure the maximum output value.
(Maintain the engine speed between
2,500 and 3,000 rpm.)
(Turn the headlamp and all the electrical
switches on.)
1.
2.
Pass: If the measured current
is 45 A or higher.
Fail: If the measured current is
less than 45 A.
Check the current of the B
terminal.
-
-
-
Move the gear selector lever to the neutral
position.
Maintain the engine speed at 2,500 rpm
with the vehicle unloaded.
(Turn all the electrical switches off.)
1.
2.
Open circuit: If the measured
current is 5 A or higher.
-
Disconnect the negative cable from the
battery.
Remove the B terminal and turn off the
ignition switch.
Measure the resistance between the L
and F terminals with an ohmmeter.
1.
2.
3.
Pass: If the measured
resistance is between 3 and
6Ω.
Faulty rotor coil or slip ring: If
the measured resistance is
less than 3Ω or greater than
6Ω.
-
-
Connect the B terminal wiring.
Measure the voltage with the engine
running.
1.
2.
Specification: 12.5V to 14.5V
Faulty IC regulator or field
coil: If the measured voltage
is 14.5V or higher.
-
-
Disconnect the negative cable from the battery.
Connect the negative cable again after connecting the ammeter.
-
-
09-7
1452-01
Troubleshooting
▶
Item
Cause
Action
Overcharged battery
Defective alternator voltage regulator
Replace
Defective voltage detection wiring
Repair or replace
Discharged battery
Loose alternator drive belt
just the belt tension or
replace
Poor connection of related circuit or open
circuit
Retighten the loose
connection or repair
open circuit
Defective alternator voltage regulator
Replace
Terminated battery
Replace
Defective ground
Repair
Charge warning lamp does
not come on when turning on
ignition switch with engine
stopped
Defective alternator voltage regulator
Replace
Open circuit in charge warning lamp, fuse
or wiring
Replace or repair the
charge warning lamp or
fuse
Defective ignition switch
Replace
Defective ground of alternator circuit
Repair
Charge warning lamp does
not go off after starting
engine
Defective alternator voltage regulator
Replace
Corroded or worn battery cable
Repair or replace
Loose alternator drive belt
Adjust the belt tension or
replace the belt
Defective wiring harness
Repair or replace
09-8
2) Battery
Inspection
▶
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст