SsangYong Korando III (2010 year). Service manual — part 420
02-9
0000-00
HFM (Hot Film Air-Mass Sensor)
HFM sensor, version 6
Refer to Chapter “Engine Control”.
Air cleaner assembly
Its volume is increased and air flowing
efficiency is improved.
Intercooler assembly
Its volume is increased and cooling efficiency is
improved.
03-3
0000-00
1. SPECIFICATIONS
Alternator
Rated output
140A (25℃, 6500rpm)
76A/1800rpm, 140A/6500rpm, 25℃, 13.5V
Battery
Capacity
90Ah(20hr)
Reserve capacity
180 minutes
Starting current (when
engine cooed)
710A
Weight
23kg
EBS
(Electronic Battery
Sensor)
Resolving power
1mA
Operating voltage
7~18V
Operating temperature
-40~105℃
Communication
LIN 2.0
Unit
Description
Specification
03-4
Item
Description
D20DTF
D20DTF (Low CO2)
Applied engine
D20DTF
Battery capacity
12V 90Ah
Alternator capacity
Delphi 120A
Delphi 140A
Alternator
Changed the diameter of belt pulley (Front view) )
Changed the regulator and control logic (Rear view)
EBS
None
Monitoring the battery conditions (voltage,
current, temperature and SOC)
2. COMPARISON
03-5
0000-00
3. BASIC INSPECTION
1) Battery Terminal
Make sure the terminal connections are
securely tightened. If the terminals are
corroded, clean them or replace the battery.
-
* Cleaning
Remove the corrosion or dirt with a wire brush
or sand paper, and then wash out with
lukewarm soapy water.
2) Measuring the Voltage Drop
Measuring at battery terminal
▶
Measure the voltage between battery
terminal (+. -) and wiring clamp.
-
Specified value
below 0.3V
If the terminals are corroded, clean and
retightening them. If the specified tightening
torque cannot be kept, replace the clamp.
Terminal (+)
Terminal (-)
Terminal (+): 4 ~ 5 Nm
Terminal (-): 6 ± 1Nm
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст