SsangYong Korando III (2010 year). Service manual — part 107
08-3
2112-01
1. SPECIFICATION
Description
Specification
Cooling system
Type
Water cooling, forced circulation
Coolant
Capacity
Approx. 8.0 ~ 8.5 L
Radiator
Core size
740W X 378.9H X 27T
Flow type
Cross flow
Antifreeze
Type
SYC 1025 (LLC)
Mixing ratio
50:50 (water:antifreeze)
Cooling fan module
Type
Electric
Capacity
180 W + 120 W
Control type
Series: low speed, Parallel: high speed
Coolant reservoir
Min. capacity
1.6 L
Circulation
Closed roof type
Pressure cap
Screw type, 1.4 bar
Thermostat
Type
Wax pallet type
Opening temperature
90℃
Fully open temperature
100℃
Valve lift
8mm
08-4
Problem
Possible Cause
Action
Coolant
level is too low
Coolant
temperature is
too high
2. INSPECTION
Leak from the radiator
Leak from the coolant auxiliary tank
Leak from the heater core
-
-
-
Leak from the water inlet cap
Leak from the thermostat housing
-
-
Reconnect the hose or replace the
clamp
Change the hose
-
-
Leak from the coolant hose connections
Damaged coolant hose
-
-
Change the gasket
Change the water pump
-
-
Leak from the water pump gasket
Leak from the water pump internal seal
-
-
Tighten the bolts to the specified
torque
Change the cylinder head gasket
-
-
Incorrect tightening torque of the cylinder
head bolts
Damaged cylinder head gasket
-
-
Change the water inlet cap gasket
Change the thermostat sealing
-
-
Coolant leakage (Coolant level is low)
Improper coolant mixture ratio
Kinked coolant hose
-
-
-
Add coolant
Check the coolant concentration
(Anti-freeze)
Repair or replace the hose
-
-
-
Defective thermostat
Defective water pump
Defective radiator
Defective coolant auxiliary tank or tank
cap
-
-
-
-
Change the thermostat
Change the water pump
Change the radiator
Change the coolant auxiliary tank or
tank cap
-
-
-
-
Change the radiator
Change the coolant auxiliary tank
Change the heater
-
-
-
Cracks on the cylinder block or
cylinder head
Clogged coolant passages in the
cylinder block or cylinder head
-
-
Change cylinder block or cylinder
head
Clean the coolant passage
-
-
Clogged radiator core
-
Replace the sensor or repair the
related wiring
-
Improper operation of cooling fan
-
Clean the radiator core
-
Defective temperature sensor or faulty
wiring
-
Replace the cooling fan or repair the
related circuit
-
08-5
2112-01
Problem
Possible Cause
Action
Coolant
temperature is
too low
Thermostat is stuck open
-
Replace the cooling fan or repair the
related circuit
-
Improper operation of cooling fan
-
Replace the sensor or repair the
related wiring
-
Defective temperature sensor or faulty
wiring
-
Change the thermostat
-
08-6
1) Coolant Level Check
Park the vehicle on level ground and apply the parking brake. Stop the engine and wait until it is
cooled down. The coolant level should be between the MAX and MIN mark on the coolant reservoir.
If the coolant level is below the “MIN” mark, immediately add coolant.
A.
B.
Coolant reservoir
MAX
MIN
Scalding hot coolant and steam could be blown out under pressure, which could cause serious
injury. Never remove the coolant reservoir cap when the engine and radiator are hot.
Avoid any direct contact of the coolant to the painted body of the vehicle.
-
-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст