SsangYong Korando III (2010 year). Service manual — part 193
08-4
3. MAJOR CHANGES
Windshield wiper blade
Wiper blade design and wiper arm pressure
Previous
Current
Wiper arm pressure
Driver side = 900 ± 50 g
Passenger side = 600 ± 50 g
Wiper arm pressure
Driver side = 950 ± 50 g
Passenger side = 650 ± 50 g
Wiper blade design changed (blade size is the same)
Driver side: 600 mm (24 in)
Passenger side: 400 mm (16 in)
08-5
7810-00
1. WIPER AND WASHER SYSTEM
1) AUTO Washer Coupled Wiper Function
If you press the AUTO washer switch briefly with the ignition key ON and INT-AUTO switch "OFF", the
washer motor is operated for about 2 seconds to spray washer fluid once after the switch is turned ON
and the wiper relay is turned ON for 4 cycles. After that, the washer motor is operated for about 2
seconds to spray the washer fluid again and the relay is turned ON for 3 cycles and then the relay is
turned OFF.
2) Rear Washer Fluid Supply System
The front washer fluid reservoir supplies the rear washer fluid without additional washer fluid reservoir.
Operating part for rear
wiper/washer
AUTO washer
switch (press)
Washer motor
08-6
3) Fluidic Washer Nozzle
This vehicle has the fluidic washer nozzle, which is designed to use fluid movement occurring in the
washer fluid spraying process.
When installing the washer nozzle, make sure that the mounting surface is clean and free of dirt or
debris, since the water may come into the engine compartment in accordance with a seamless
contact condition between the mounting surface of the nozzle and the curved surface of the engine
hood.
*
The inside of the nozzle is designed in a fan shape to change the spray direction continuously based on
the time the fluid is sprayed. Refer to the figure below.
The spray direction is changed by means of the whirlwind and back flow generated while the washer
fluid is passing through the nozzle.
Washer fluid inlet port
Spray passage
Counter-current
Passage
Washer fluid outlet port
Whirlwind
Washer nozzle
08-7
7810-00
2. RAIN SENSING SYSTEM
In the rain sensing wiper operation system, the rain sensing unit only sends the information about the
amount of rain drops to the BCM, and it does not operate the wiper directly. The wiper and washer are
controlled by the BCM according to the driver's choice.
Rain sensing unit
Multifunction wiper switch
AUTO and sensitivity control
This sensor emits infrared rays through LED
and then detects the amount of rain drops
by receiving the rays reflected off the
sensing section (rain sensor mounting
section on the windshield) with photodiode.
AUTO: Wiper operates automatically by rain
sensor
FAST <-------> SLOW:
Auto delay/auto speed control.
A position that can control the sensitivity for
the amount of rains on the windshield and
transmit the wiping request signal
accordingly.
Rain sensor emitter lens
Auto light sensor sensing
portion
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст