SsangYong Korando III (2010 year). Service manual — part 575
01-30
(2) Temperature control
The temp actuator controls the temperature of air discharged depending on the temperature control dial
operation by the driver. The driver can select one of the 17 levels.
Blower
step
Blower motor voltage
(V)
1
4.0
2
5.0
3
6.0
4
7.5
5
9.0
6
10.5
7 VIGN
(3) Blower control
The fan speed increments by 1 level per
revolution of the fan speed dial. (allowance:
±0.5 V)
Temperature control dial
Fan speed dial
01-31
6810-00
(4) Air source control
When pressing the air source selection switch, the air source mode is changed via the intake actuator's
operation. The air source mode is switched between the fresh air and recirculation alternatively each
time the switch is pressed. You can see the air source mode through the switch's indicator. (the indicator
comes on at recirculation mode)
Control by vehicle speed
▶
The air source selection is controlled in accordance with the vehicle speed while driving. Operating
conditions and control process are as follows:
When the PTC heater operates at fresh air mode in winter
When the vehicle speed is 45 km/h or lower in fresh air mode, the air source door is open 30% of its
maximum opening. If the vehicle speed is 65 km/h or more, then the air source door is completely
open.
-
-
However, the electronic fan should be more than 7.5 V.
Air source selection switch
01-32
(5) Air distribution control
The driver can select one of 5 air distribution modes using the 5 air distribution switches in the center of
the MTC The selected air distribution mode is changed by the mode actuator and acknowledged by the
indicator for each switch coming on
Vent mode
▶
If the vent mode switch is pressed, the indicator comes on while the air flows to the
upper part of the body.
Bi-level mode
▶
Foot mode
▶
If the bi-level mode switch is pressed, the indicator comes on while the air flows to
the footwell and upper part of the body.
If the foot mode switch is pressed, the indicator comes on while the air flows to the
footwell.
Defroster mode switch
Bi-level mode switch
Foot mode switch
Vent mode switch
Defroster & foot mode switch
01-33
6810-00
Defroster & foot mode
▶
If the defroster & foot mode switch is pressed, the indicator comes on while the air
flows to the footwell and the windshield.
Defroster mode
▶
This is used to remove the condensation from the windshield. When you press the
switch, the indicator comes on and the air distribution is changed to the windshield
at the same time, then the air conditioner starts to operate.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст