SsangYong Stavic / SsangYong Rodius (2005 year). Service manual — part 259
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
MULTIMETER
STAVIC - 2004.09
10
2F
3) Speed Sensing Indicator
The flashing interval of the road signs changes gradually ac-
cording to the vehicle speed.
Flashing interval according to the vehicle speed
4) Driving Time
- It indicates the driving time from start up to now.
- It can be reset to 0 when turning the ignition key to “OFF”
position or pressing UP or DOWN button for a specific
period of time.
- Indication range: 0:00 ~ 23:59
5) Average Speed
- It indicates the average vehicle speed from start up to
now.
- It can be reset to 0 km/h when turning the ignition key to
“OFF” position or pressing UP or DOWN button for a
specific period of time.
- Indication range: 0 ~ 120 km/h
Vehicle speed
below 1.8 km/h
below 40 km/h
below 60 km/h
below 80 km/h
below 100 km/h
over 100 km/h
Flashing interval
stays ON
1 second
0.8 seconds
0.5 seconds
0.3 seconds
0.2 seconds
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
MULTIMETER
STAVIC - 2004.09
11
2F
6) Parking Aid Signal Mode
The rearview display appears when placing the gear selector lever to “R” position.
This message appears when the
parking aid sensor is defective.
Display changes according to the distance between rear bumper and rear obstacle
All displaying bars are displayed when the distance between rear bumper and obstacle is over 120 cm.
The number of displaying bars is decreased and the alarm interval becomes faster as the obstacle approaches.
Rear left sensor
Rear center
sensor
Rear right
sensor
Detecting obstacle at rear
left of the vehicle
Detecting obstacle at rear
center of the vehicle
Detecting obstacle at rear
right of the vehicle
Detecting obstacle at rear right
and rear center of the vehicle
[Note]
The display returns back to previous mode screen when
placing the selector lever to other positions.
Step
Step 1
Step 2
Step 3
Distance
80 ~ 120 cm
50 ~ 80 cm
below 50 cm
Alarm interval (msec)
Display
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
MULTIMETER
STAVIC - 2004.09
12
2F
7) Battery Mode
- The screen shows fully charged battery when the battery voltage is over 12 V.
- It indicates the current battery voltage by 0.1 V.
- When the battery voltage goes below 9 V, current display is changed to battery voltage mode and “LOW VOLTAGE”
message flashes.
Charging Level
Charging level
Battery voltabe
Over 12.0 V
(fully charged)
11.9 ~ 11.0 V
10.9 ~ 10.0 V
9.9 ~ 9.0 V
Battery voltage
Indication
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
MULTIMETER
STAVIC - 2004.09
13
2F
REMOVAL AND INSTALLATION
1. Open the sunglasses box, remove two screws from the
box, and pry off the overhead console with a flat blade
screwdriver.
2. Disconnect the multi-meter connector and the room lamp
connector and remove the overhead console.
3. Unscrew three screws from the back of the overhead console and remove the multi-meter.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст