SsangYong Stavic / SsangYong Rodius (2005 year). Service manual — part 386
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
POWER STEERING
STAVIC - 2004.09
20
4G
Removal and Installation
1. Remove the power steering pipes
(A: High, Low pressure) and lower arm
shaft (B) at the rear side of syb frame.
2. Remove the front calier (C) and wheel speed sensor (D)
(Fix the caliper and speed sensor on the body. Disconnect the
brake hose clip)
3. Unscrew the power steering pipe mounting
bracket (1, 2) and release them
4. Unscrew the knuckle upper bolt (E) and
shock absorber lower bolt/nut (F) and then,
remove the shock absorber from knuckle.
Power steering
pipes (Front)
Wheel
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
POWER STEERING
STAVIC - 2004.09
21
4G
5. Leave mark with a marking painter on the sub frame mounting bolts.
(Tightening torque: 95 ~ 142 Nm)
6. Locate two sypplement lifts under sub frame (Front/Rear) and unscrew the sub frame mounting bolts (19mm -
6EA).
And then, drop the lifts slowly.
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
POWER STEERING
STAVIC - 2004.09
22
4G
7. Unscrew the clamp mounting bolt of stabilizer bar and fix to the upper side of axle flange.
8. Remove the coat pin and nut(1), and unscrew the gear box clamp bolt(2) and bush mounting nut(3).
1. Tie rod end
A. Stabilizer
1. Tie rod end
2. Clamp mounting bolt
1. Coat pin and nut
2. Clamp mounting bolt
Tightening torque
25 ~ 30 Nm
Tightening torque
100 ~ 130 Nm
3. Bush mounting nut
Tightening torque
Upper bolt : 70 ~ 90 Nm
Lower bolt : 70 ~ 90 Nm
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
POWER STEERING
STAVIC - 2004.09
23
4G
9. Disassemble the steering gear box as shown below with arrow mark.
10. Install in the reverse order of removal.
Sloted nut
: 25 ~ 30 N
.
m
Gear box mounting bolt
(Bushing)
: 70 ~ 90 N
.
m
Gear box mounting bolt(Clamp)
: 70 ~ 90 N
.
m
Sloted nut
: 25 ~ 30 N
.
m
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст