SsangYong Stavic / SsangYong Rodius (2005 year). Service manual — part 380
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
31
REAR SUSP & AXLE
STAVIC - 2004.09
4F
Rear Axle Shaft
Preceding work: Removal of wheel and tire
1. Unscrew rear axle shaft mounting bolts from axle housing
(6 EA).
2. Unscrew lock nut (30 mm) from wheel disk side and
remove the axle shaft.
3. REMOVAL AND INSTALLATION
Tightening torque
Initial: 70 ~ 80 Nm
Secondary: 90 ± 5°
[Notice]
Replace the lock nut to new one by every disassembly.
Tightening torque
200 ~ 240 Nm
[Notice]
Replace the bolts by every removal
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
32
REAR SUSP & AXLE
STAVIC - 2004.09
4F
Rear Axle Housing
Preceding work: Removal of rear axle shaft
1. Support the axle housing with mounting jack.
2. Unscrew one front mounting bolt and two rear mounting bolts to remove the axle housing from the rear sub frame.
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
33
REAR SUSP & AXLE
STAVIC - 2004.09
4F
Replacement of Radial Sealing and
O-ring
Preceding work: Removal of rear axle housing
1. Drain oil in the axle housing.
2. Remove the axle mounting damper
4. Remove the connecting flange snap ring with special tool.
3. Remove the axle housing cover and damper bracket.
[Notice]
Damper bolt should be replaced by ecery removal.
Tightening torque
90 ± 110 Nm
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
34
REAR SUSP & AXLE
STAVIC - 2004.09
4F
Inner flange
Snap ring
Back lash adjust shim
O-ring
Shim
Radial sealing
5. Pull out the inner flange.
6. Remove the radial sealing with a tool.
7. To replace the O-ring, unscrew the side bearing cover
mounting bolts.
8. Remove shim and replace the O-ring.
Tightening torque
20 ± 4 Nm
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст