SsangYong Stavic / SsangYong Rodius (2005 year). Service manual — part 58
1F-74
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE CONTROLS
M162 GSL ENG SM - 2005.7
8. Using the fuel tank cap wrench 661 589 00 46 00, remove
the locking cap.
9. Remove the pump from the fuel tank.
Notice
Check the condition of the seal and replace if
necessary. Drain the fuel before removing the pump.
10. Perform an operational check of the fuel pump.
11. Installation should follow the removal procedure in the
reverse order.
FUEL FILTER
Removal and Installation Procedure
1. Disconnect the negative battery cable.
Caution
The fuel system is under pressure. To avoid fuel
spillage and the risk of personal injury or fire, it is
necessary to relieve the fuel system pressure before
disconnecting the fuel lines.
2. Relieve the fuel system pressure. Refer to “Discharging
the Pressure in Fuel System” in this section.
3. Disconnect the fuel lines from the fuel filter.
Installation
4. Remove the fuel filter mounting bracket bolt.
Installation
Tightening torque
28 Nm (21 lb-ft)
Tightening torque
28 Nm (21 lb-ft)
Notice
Place the fuel pump pad. There may be a corrosion
due to the contact between the fuel filter and the
bracket.
5. Remove the fuel filter.
6. Install the fuel filter.
7. Perform a leak test of the fuel filter.
8. Installation should follow the removal procedure in the
reverse order.
1F-75
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE CONTROLS
M162 GSL ENG SM - 2005.7
FUEL TANK
Removal and Installation Procedure
Caution
The fuel system is under pressure. To avoid fuel
spillage and the risk of personal injury or fire, it is
necessary to relieve the fuel system pressure before
disconnecting the fuel lines.
1. Relieve the fuel pressure. Refer to “Discharging the
Pressure in Fuel System” in this section.
2. Disconnect the negative battery cable.
3. Drain the fuel tank.
4. Disconnect the return line.
5. Disconnect the supply line.
6. Disconnect the fuel tank-to-canister hose from the fuel
tank.
7. Disconnect the fuel pump wiring connector.
8. Disconnect the fuel supply hose, fuel return hose.
1F-76
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE CONTROLS
M162 GSL ENG SM - 2005.7
10. Install the safety jack under the fuel tank and remove the
bolts (12mm x 4) from the fuel tank.
9. Unscrew the bolts and remove the fuel filler pipe from the
fuel filler opening.
1F-77
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE CONTROLS
M162 GSL ENG SM - 2005.7
11. Carefully lower the safety jack with the fuel tank.
Caution
Be careful not to drop the fuel tank while removing
it.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст