SsangYong Stavic / SsangYong Rodius (2005 year). Service manual — part 366
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
FRONT SUSP & AXLE
STAVIC - 2004.09
12
4E
REMOVAL AND INSTALLATION
1. COMPONENTS
Front Syspension Assembly
1. Coil spring
2. Shock absorber
3. Upper bracket
4. bush
5. Lower bush
6. Spring-upper rubber sheet
7. Dust cover
8. Cam bolt
9. Stopper-bumper
10. Lower arm rubber bush
11. Lower arm
12. Lower arm ball joint
13. Knuckle
14. Upper arm ball joint
15. Upper arm
16. Upper arm bush
4WD
2WD
17. Axle shaft
18. Brake dust shield
19. Lock nut
20. Hub assembly
21. Washer
22. Brake disk
23. Hub assembly
13. Knuckle
18. Brake dust shield
13. Knuckle
21. Washer
22. Brake disk
19. Lock nut
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
FRONT SUSP & AXLE
STAVIC - 2004.09
13
4E
Front Axle Assembly
Air bleeder
Carrier cover
Ring gear
Pinion gear
Ball bearing
Axle mounting bracket
Oil seal
Inner shaft
Snap ring
Shim
Axle housing
Ball bearing
Lock nut
Flage
Shim
Axle shaft assembly
Axle mounting bracket
Pinion drive seal
Ball bearing
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
FRONT SUSP & AXLE
STAVIC - 2004.09
14
4E
1. Install the safety wedge under both rear wheels
Because the weight balance move to rear when the sub
frame is removed, safe working condition must be
prepaired.
For this reason, Installing the safety jack to both under
body is important to avoid unexpectable accident.
(The height of safty jack to both side must be same)
The supplement lift is used when you remove or install the sub frame
(Keep in mind the center of gravity of sub frame locate near front axle mounting point)
Front
Rear
2. PRECEDING WORK FOR SUB FRAME REMOVAL
16.5 cm
(Put the shifting lever in “P” position and apply the parking brake)
2. Additional safety jack
3. The mounting location of suplement lift
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
FRONT SUSP & AXLE
STAVIC - 2004.09
15
4E
4. Remove the engine lnsulating brackets from the front sub frame as the
engine hung by an additional lift (crane)
5. Install the engine mounting bracket
Before removal of sub frame, install the special tool (Engine mounting
brackets) on the body frame
RH
LH
RH
LH
RH
Part number : A9912 008 2B
Engine mounting
brackets on the body
Engine insulating
brackets on the sub frame
LH
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст