SsangYong Stavic / SsangYong Rodius (2005 year). Service manual — part 267
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
PARKING ASSISTANCE SYSTEM
STAVIC - 2004.09
3
2H
COMPONENTS OF PARKING AID SYSTEM
(PARKING AID SYSTEM + REARVIEW CAMERA)
1. REARVIEW CAMERA EQUIPPED VEHICLE
When moving the gear selector lever into R (Reverse) position while watching DVD or VCD, the rearview appears on the
front monitor but the rear monitor continuously shows current screen.
Multi-meter
Even in other modes, it is changed to the parking
aid screen when moving the gear selector lever into
“R” position.
Front monitor
When moving the gear selector lever into
“R” position while watching DVD or VCD,
the rearview appears on the front monitor.
ICM box
When moving the gear selector lever into “R”
position, the alarm buzzer in ICM box sounds
(installed at bottom of STICS).
Rearview camera
When selecting R position while A/V system is in use:
• The video mode in front A/V system is changed to rear-
view monitoring mode. However, the audio mode stays on.
• The video mode in front A/V system resumes when
shifting out from “R” position.
• The audio and video mode in rear A/V system are not
changed.
When selecting R position while A/V system is not in use:
• Both monitors are automatically turned on to display rearview.
• Both monitors are automatically turned off when shifting
out from “R” position.
Parking aid sensor
(Rear bumper)
Rearview camera
PAS unit
The three parking aid sensors send the distance
data between rear bumper and obstacle to PAS
unit.
The rearview camera sends the rear-
view to the monitor by using wide angle
lens.
It is a control unit for the parking aid system (PAS)
and transmits the signals from sensors to multi-
meter and buzzer.
(installed in tuner/amplifier bracket)
R
Gear selector lever
(R position)
Applies power to parking aid system.
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
PARKING ASSISTANCE SYSTEM
STAVIC - 2004.09
4
2H
2. SYSTEM CONTROL
Parking Aid Unit
Parking Aid Sensor
Generates sensor
driving signals
Back
sonar
Signal transmitter
Regulator
AMP
& BPF
Send
12 V
GND
Receive
Reverse driving
(supplies power)
Back sonar
sensor
(LH)
Back sonar
sensor
(Center)
Back sonar
sensor
(RH)
Buzzer
(ICM box)
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
PARKING ASSISTANCE SYSTEM
STAVIC - 2004.09
5
2H
3. PARKING AID SYSTEM (PAS)
1) System Configuration
Rear left obstacles
Rear center obstacles
Rear right obstacles
PAS unit
Tuner
Amplifier with
built-in DSP
This unit controls the parking aid system. One of 3
LEDs comes on when the corresponding parking
aid sensor is defective and shows below mes-
sage on multi-meter.
Left sensor
Center sensor
Right sensor
Multi-meter
Rear left sensor
Rear center sensor
Rear right sensor
Parking aid
buzzer
Navigation unit
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
PARKING ASSISTANCE SYSTEM
STAVIC - 2004.09
6
2H
1) Parking aid unit
Detecting type: Super sonic wave
Detecting distance: 25 ~ 120 cm (distance between sensor
and obstacle)
2) Parking aid sensor
- Type: Piezo ceramic element
- Frequency: 40 KHz ± 2 KHz
- Detecting range (13.5 V)
* Horizontal: Min. 20
° at 110 ± 5 cm
Min. 100
° at 50 ± 5 cm
* Vertical: Min. 20
° at 110 ± 5 cm
Min. 60
° at 50 ± 5 cm
Descriptions
Value
Operating temperature
Storage temperature
Relative humidity
-30
°C ~ +80°C
-40
°C ~ +85°C
95%RH max
160g ± 10g max
70g ± 10g max
4. COMPONENT SPECIFICATIONS
The parking aid system emits the supersonic wave signals from the sensors on the rear bumper with a specific interval
and detects the reflected signals from obstacles while the gear selector lever is in “R” position.
The number of displaying bars is decreased and the alarm interval becomes faster as the obstacle approaches. This
supplementary system is to secure the safety distance for parking.
DC 12 V
DC 9 V ~ 16 V
Below 100 mA
Below 20 mA (each)
Over 5 M
Ω
Rated voltage
Operating voltage
Sensor insulating resistance
Weight
Unit
Sensor
Unit
Sensor
Current
consumption
Descriptions
Value
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст