SsangYong Musso. Service manual — part 430
3D-6 REAR DRIVE AXLE
MAINTENANCE AND REPAIR
ON-VEHICLE SERVICE
AXLE SHAFT
1 Brake Disc
2 Dust Plug
3 Rear Axle Shaft
4 Nut . . . . . . . . . . . . . ... 50-65 Nm
5 Washer
6 Parking Brake Cable
7 Parking Brake Lining and Back Plate Assembly
8 Caliper Assembly
9 Gasket
10 Bolt . . . . . . . . . . . . . 85-100 Nm
11 Rear Axle Housing
REAR DRIVE AXLE 3D-7
Removal & Installation Procedure
1. Remove the tire.
Installation Notice
2. Release the parking brake.
Steel Wheel
Aluminum Wheel
Tightening Torque
3. Remove the bolts and the brake caliper.
Installation Notice
Be careful not to damage the brake hose.
Tightening Torque
85 - 100 Nm
4. Remove the brake disc.
Notice
To remove the disc, install the bolts (M8 x 1.25) into the
service hole and uniformly tighten the bolts.
5. Disconnect the parking brake cable.
80 - 120 Nm
110 - 130 Nm
3D-8 REAR DRIVE AXLE
Tightening Torque
50 - 65 Nm
6. Remove the plug from the axle shaft flange and remove the
inner shaft mounting nuts.
Installation Notice
7. Remove the axle shaft, parking brake lining and back plate
assembly.
8. Installation should follow the removal precedure in the
reverse order.
REAR DRIVE AXLE 3D-9
AXLE
Removal & Installation Procedure
1. Lift up the vehicle and support the frame safely.
2. Remove the axle shaft.
Tightening Torque
150 - 180 Nm
3. Remove the propeller shaft from the rear axle input shaft.
Installation Notice
Notice
Place alignment marks before removal.
Tightening Torque
81 - 89 Nm
4. Disconnect the parking brake cable and brake hose.
5. Remove the lower arm mounting nuts and remove the lower
arm from the axle housing.
Installation Notice
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст