SsangYong Musso. Service manual — part 309
1E2-6 M161 ENGINE ELECTRICAL
BATTERY
1 Cable Terminal (-)
2 Cable Terminal Cap (-)
3 Cable Terminal Cap (+)
4 Nut
5 Fuseblink Box
6 Terminal (+)
7 Battery holddown Bracket
8 Battery Clamp Bolt
9 Battery
10 Sub Tray
11 Battery Tray
Removal & Installation Procedure
Notice
z
Disconnect the battery negative cable first.
z
Insert the clamp bolt (8) into the battery tray hole (11)
from inside when installing.
M161 ENGINE ELECTRICAL 1E2-7
SPARK PLUG
Preceding Work : Removal of intake air duct
Tools Required
119 589 01 09 00 Spark Plug Wrence
1 Screw (3 pieces) . . . . . . . . .. 9 - 11 Nm
2 Adaptor (3 pieces)
3 Ignition Coil Cable Cover
4 Spark Plug Connector
5 Ignition Coil Connector
6 Bolts (M6 X 25, 4 pieces) . . . . . . 9 - 11 Nm
7 Ignition Coil (T1/1)
8 Coupling Plug
9 Spark Plug . . . . . . . . . . . 25 - 30 Nm
10 Ignition Coil (T1/2)
1E2-8 M161 ENGINE ELECTRICAL
Tightening Torque
9 - 11Nm
Replacement Procedure
1. Unscrew the three screws(1) and remove the ignition coil
cable cover
Installation Notice
Tightening Torque
Clearance
25 - 30 Nm
0.8 + 0.1 mm
2. Disconnect the cable from ignition coil and spark plug.
4. Using the special tool, remove the spark plug .
Installation Notice
Spark Plug Wrench 119 589 01 09 00
Notice
z
Tighten the spark plug with specified torque.
z
Install the ignition coil to number 2 and 4 cylinder, and
connect the cable to number 1, 4 and 2, 3 cylinder
- T1/1 : cylinder 1 and 4
- T1/2 : cylinder 2 and 3
3. Unscrew two bolts(M6 X 25) from each ignition coil and
remove the ignition coil(arrow) .
Installation Notice
Tightening Torque
9 - 11Nm
M161 ENGINE ELECTRICAL 1E2-9
IGNITION CABLE
Preceding Work : Removal of intake air duct
1 Control Cable Connection
2 Ignition Cable
3 Spark Plug Connector
4 Coupling Plug
5a, 5b
Secondary Voltage Connection
E Iron Core
L1
Secondary Ignition Coil
L2
Primary Ignition Coil
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст