SsangYong Rexton. Service manual — part 442

SSANGYONG Y200

1F2-94 M161 ENGINE CONTROLS

PURGE CONTROL VALVE

Removal and Installation Procedure

1. Disconnect the negative battery cable.

2. Disconnect the purge control valve connector.

3. Disconnect the throttle body-to-purge control valve

hose from the purge control valve.

4. Disconnect the canister-to-purge control valve

hose from the purge control valve.

5. Remove the purge control valve.

6. Installation should follow the removal provedure

in the reverse order.

YAA1F800

YAD1F670

YAA1F810

3. Remove the canister mounting bolts.

Installation Notice

CAMSHAFT POSITION SENSOR

Removal and Installation Procedure

1. Disconnect the negative battery cable.

2. Disconnect the electrical connector from the cam-

shaft position sensor.

3. Remove the camshaft position sensor retaining

bolt.

Installation Notice

YAD1F660

CANISTER

Removal and Installation Procedure

Caution: Canister and vacuum hoses contain fuel
vapors. Do not smoke in the area or permit an open
flame.

1. Disconnect the fuel tank-to-canister hose form the

canister.

2. Disconnect the canister-to-purge control valve

hose form the canister.

Tightening Torque

6 N•m (53 lb-in)

4. Remove the canister.

5. Installation should follow the removal procedure

in the reverse order.

Tightening Torque

10 N•m (89 lb-in)

M161 ENGINE CONTROLS 1F2-95

SSANGYONG Y200

4. Check the O-ring for damage and replace it if

necessary.

5. Installation should follow the removal procedure

in the reverse order.

KAA1F200

ENGINE CONTROL MODULE

Removal and installation Procedure

1. Disconnect the negative battery cable.

2. Remove the cowl side trim form passenger side.

Re-er to Section 9G, Interior trim.

3. Remove the four securing nuts for the Engine

Control Module (ECM) from the mounting bracket.

Installation Notice

KAA1F160

CRANKSHAFT POSITION SENSOR

Removal and installation Procedure

1. Disconnect the negative battery cable.

2. Disconnect the electrical connector at the crankshaft

position sensor.

3. Remove the crankshaft position sensor retaining bolt.

Installation Notice

Tightening Torque

10 N•m (89 lb-in)

4. Installation should follow the removal procedure

in the reverse order.

Tightening Torque

10 N•m (89 lb-in)

4. Pull out the ECM from the bracket.

5. Disconnect the vehicle side coupling.

6. Installation should follow the removal procedure

in the reverse order.

SSANGYONG Y200

1F2-96 M161 ENGINE CONTROLS

ECM WIRING DIAGRAM (2.3L DOHC - 1 OF 7) (MSE 3.53D)

SCHEMATIC AND ROUTING DIAGRAMS

YAD1F010

M161 ENGINE CONTROLS 1F2-97

SSANGYONG Y200

ECM WIRING DIAGRAM (2.3L DOHC - 2 OF 7) (MSE 3.53D)

Y

AD1F0A0