SsangYong Rexton. Service manual — part 479
FRONT AXLE 3A-11
SSANGYONG Y200
ON-VEHICLE SERVICE
FRONT AXLE SHAFT
Removal
1. Remove the tire.
YAD3A050
YAD3A070
YAD3A060
2. with ABS (Only part time vehicle)
Remove the wheel speed sensor from the steering
knuckle and pull off the cable.
3. Remove the split pin from steering linkage link-
knuckle mounting and pull off the slot nut and
detach the link from knuckle arm.
Notice: Replace the split pin with new one when
it is installed again.
MAINTENANCE AND REPAIR
SSANGYONG Y200
3A-12 FRONT AXLE
5. Vehicle with pant time transfer case only
•
Remove the hub mounting bolt & washer and
pull off the hub cover.
YAD3A100
YAD3A110
•
Remove the retainer ring & outer shin in the
drive shaft and pull off the lock.
Notice: For assembly, adjust the clearance
between the snap ring & hub not to exceed 0.2mm.
(Shim thickness : 0.2, 0.3, 0.5, 1.0mm)
Notice: For assembly, be careful not to damage
O-ring of the locking hub.
•
Detach the vacuum hose of locking hub from
steering knuckle.
YAD3A090
4. Remove the two knuckle-brake caliper assembly
mounting blots and pull off the caliper assembly.
Notice: Be careful not to damage the brake oil hose.
YAD3A080
FRONT AXLE 3A-13
SSANGYONG Y200
YAD3A140
YAD3A150
YAD3A130
6. With full time transfer case only
•
Remove the hub nut & washer.
Notice: For assembly, after you coincide the
groove of drive shaft tip with the hub tip and cork,
apply the paint and grease to the corking part.
•
Remove the front disc assembly from the axle
shaft.
•
Remove three wheel bearing bolts (M12) and
pull off hub assembly by using the special tool.
Notice: For reassembly, replace the wheel bearing
bolt with new one which applied the lock tight (blue
color).
YAD3A120
•
Remove the hub & brake disc assembly.
SSANGYONG Y200
3A-14 FRONT AXLE
YAD3A180
YAD3A190
YAD3A170
8. Remove the split pin and nut from the steering
knuckle arm and upper arm ball joint connection.
Notice: For assembly, replace the split pin with
new one.
9. Remove the split pin and nut from the steering
knuckle arm and lower arm ball joint connection.
Notice: For assembly, replace the split pin with
new one.
10. Carefully remove the steering knuckle assembly.
11. Remove the drive shaft using the special tool.
YAD3A160
7. Remove two dust shield mounting bolts (M6) and
pull off the dust shield.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст