SsangYong Rexton. Service manual — part 147
DI10-193
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
DIAGNOSIS
DI ENG SM - 2004.4
4-5 High Pressure Pump Test
1. Prepare the special tools for high pressure pump test
and thoroughly clean the system.
Y220_10083
Y220_10084
Y220_10085
Y220_10086
2. Remove the high pressure fuel supply pipe and install
the closed rail delivered with tool kit.
3. Install the opposite end of the closed rail into the fuel rail
for test.
4. Remove the high pressure fuel return hose and install
the transparent tube between the high pressure pump
and the return port of fuel rail for test.
Specified value
40 Nm
Specified value
40 Nm
* The figure is to show the test method. However, the
actual test operation should be done while the high
pressure pump is installed in vehicle.
DI10-194
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
DIAGNOSIS
DI ENG SM - 2004.4
Y220_10087
5. Connect the digital tester connector into the sensor
connector of fuel rail for test.
6. Disconnect the IMV connector and the fuel rail pressure
sensor connector.
7. Check if the measured value on the digital tester meets
the specified value.
Specified value
Over 1,050 bar
Y220_10088
REXTON (1 OF 2)
ENGINE SERVICE MANUAL
TELEPHONE : 82-31-610-2740
FACSIMILE
: 82-31-610-3762
ISSUED BY
INTERNATIONAL A/S TEAM
SSANGYONG MOTOR CO., LTD.
150-3, CHILGOI-DONG, PYUNGTAEK-SI
GYEONGGI-DO, 459-711 KOREA
NOTE:All rights reserved. Printed in SSANGYONG Motor Co., Ltd.
No part of this book may be used or reproduced without the
written permission of International A/S Team.
HOW TO USE
ELECTRICAL WIRING
DIAGRAM
POSITION OF
CONNECTORS AND
GROUNDS
WIRING DIAGRAM FOR
POWER SUPPLIES
USAGE AND CAPACITY
OF FUSES IN FUSE BOX
ELECTRICAL WIRING
DIAGRAMS
SECTION INDEX
1
2
3
4
5
(RHD)
ELECTRICAL WIRING
DIAGRAM
PYUNGTAEK, KOREA
SSANGYONG MOTOR CO., LTD.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст