SsangYong Rexton. Service manual — part 503
REAR BRAKE 4C-3
SSANGYONG Y200
DISC BRAKE
The disc brake uses at front wheel generally and
recently has been using at rear wheel. The floating
type caliper disc brake installed by this vehicle installs
only brake cylinder per caliper at one side. When the
master cylinder generates the hydraulic pressure, the
piston pushes the pad in order to compress to the
disc and at this time, the caliper is moved by this
reaction resulted in pushing the pad at the other side
to compress to the disc. Because the brake disc
contacts atmospheric conditions and effect on good
radiation, the braking variation keeps uniform forces,
the uneven braking may not be generated on high
speed driving.
YAD4C030
Application
Delphi Korea
-
-
-
-
Ø 42 mm
10 mm
10.4 mm
Drum I.D.
Shoe Type
Lining Width x Length x Thickness
Wheel Cylinder I.D.
Caliper Cylinder I.D.
Brake Pad Thickness
Disc Thickness
SPECIFICATIONS
MANDO
-
-
-
-
Ø 42.9 mm
10 mm
10.4 mm
Disc Brake
Drum Brake
Ø 254 mm
Leading and Trailing
55 x 243 x 4.7 mm
Ø 23.81 mm
-
-
-
SSANGYONG Y200
4C-4 REAR BRAKE
Lining Wear, Hardening
Oil Or Water Contamination On The Lining
Inoperative Wheel Cylinder
Inoperative Clearance Automatic Control System
Lining Wear, Hardening
Oil Or Water Contamination On The Lining
Inoperative Wheel Cylinder
Inoperative Clearance Automatic Control System
Damage Of The Brake Shoe Return Spring
Inoperative Wheel Cylinder Returning
Lining Wear
Inoperative Clearance Automatic Control System
Lining Wear, Hardening
Foreign Material Inside Drum
Loosen The Brake Plate Bolt
Drum Deformation Or Surface Damage
Lining Wear, Hardening
Oil Contamination On The Lining
Inoperative Clearance Automatic Control System
Replace
Replace or Repair
Replace
Repair
Adjust
Replace or Repair
Replace
Repair
Replace
Replace
Replace
Repair
Replace
Clean
Tighten
Replace
Replace
Replace
Repair
Poor Braking
Uneven Braking
Dragging Brake
Excessive Pedal Travel
Noise and Vibration When
Brake Applied
Inoperative Parking Brake
DIAGNOSTIC INFORMATION AND PROCEDURES
Symptom
Possible Cause
Action
REAR BRAKE 4C-5
SSANGYONG Y200
;;;;
;;;;
;;;;
;;;;
;;;;
;;;;
yyyy
yyyy
yyyy
yyyy
yyyy
yyyy
;;;;;
;;;;;
;;;;;
;;;;;
;;;;;
;;;;;
;;;;;
yyyyy
yyyyy
yyyyy
yyyyy
yyyyy
yyyyy
yyyyy
INSPECTION
YAD4C060
YAD4C070
YAD4C080
Inside Diameter
Ø 254 mm
Wear Limit
Ø 255.5 mm
DRUM BRAKE TYPE
1. Inspect the drum for crack or damage or defor-
mation.
2. Measure the inside diameter.
•
Measure two more position.
Brake Lining
1. Inspect the surface hardening or excessive wear
of the lining. Inspect the lining for stain with oil.
2. Measure the lining thickness.
Wear Limit
1 mm
•
If the measured value is below the limit value,
replace the brake lining.
DISC BRAKE TYPE
Pad Thickness
1. Remove the front wheel.
2. If the measured value is below the limit value,
replace the pad.
Wear Limit
2 mm
SSANGYONG Y200
4C-6 REAR BRAKE
Max. 0.07 mm
Max. 0.03 mm
2. If lateral run out exceeds the specification, replace
the brake disc to prevent the pedal’s vibration at
braking.
YAD4C090
YAD4C100
Brake Disc Thickness
1. Measure the thickness of the rotor at four or more
points around the circumference of the disc.
2. If the thickness of the brake disc is below the
specified value, replace the brake disc.
Disc Thickness Limit
8.5 mm
Brake Disc Run Out
1. Set a dial indicator to the brake disc side and
measure the run out by rotating the disc.
On-Vehicle
Disc only
Run Out Limit
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст