SsangYong Rexton. Service manual — part 482
FRONT AXLE 3A-23
SSANGYONG Y200
Assembly
1. Clean all parts and check the followings.
•
Check the ring gear, drive pinion for wear and
damage. If damaged, replace it as a set.
•
Check the bearing for sticks, wear, noise and
turning resistance.
•
Check the side gear, pinion, pinion shaft and
thrust washer for wear and damage.
•
Check the differential carrier for crack and wear
(bearing contact surface). Check the gear case
for crack.
YAD3A560
YAD3A570
YAD3A590
YAD3A580
2. Assemble the drive pinion assembly to the axle
housing and then tighten the pinion lock nut.
Installation Notice
Tightening torque
240 - 310 N•m
Tightening Torque
75 - 90 N•m
(55 - 66 lb-ft)
3. Assemble the differential carrier assembly. Align
the ring gear to the mark of differential carrier,
tighten the fixing bolts.
Installation Notice
4. Measure the backlash of side gear and pinion gear.
Specified value
0 - 0.5 mm
SSANGYONG Y200
3A-24 FRONT AXLE
YAD3A600
YAD3A610
YAD3A630
YAD3A620
5. Install the differential carrier assembly into the axle
housing. Set up the bearing cap and then tighten
the cap bolts.
Installation Notice
Notice: Be careful not to change the caps. Be sure
to keep the original position of the caps.
Tightening Torque
48 - 69 N•m
(35 - 51 lb-ft)
6. Measure the backlash of drive pinion and ring
gear.
Specified value
0.13 - 0.20 mm
7. Install the axle housing cover. Tighten the fixing
bolts.
Installation Notice
8. Assemble the parts of the front axle inner shaft
and housing mounting bracket.
Notice: Apply the grease to the oil seal rib.
Tightening Torque
39 - 46 N•m
(29 - 34 lb-ft)
FRONT AXLE 3A-25
SSANGYONG Y200
YAD3A640
9. Align the axle shaft and differential carrier spline
and insert the axle shaft. Assemble the axle
housing mowiting bracket to the axle housing.
Installation Notice
Tightening Torque
80 - 100 N•m
(59 - 74 lb-ft)
SSANGYONG Y200
3A-26 FRONT AXLE
6. Remove the drive axle shaft boot.
YAD3A680
3. Detach the joint housing from the boot.
1 Boot
2 Joint housing
YAD3A650
YAD3A670
YAD3A660
DIFFERENTIAL JOINT ASSEMBLY
1. Remove the drive axle.
2. Detach the joint boot clamp.
1 Detach the boot clamp (large)
•
After pressing the clamp prominence using the
special tool, detach the clamp.
2 Detach the boot clamp (small)
•
After unfolding the clamp holding part using the
driver / hammer, detach the clamp.
4. Get rid of the grease in the joing assembly.
5. Remove the triport joint.
1 Pull out the circlip.
2 Pull out the triport joint.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст