SsangYong Rexton. Service manual — part 672
SSANGYONG Y200
9D-2 BODY ELECTRICAL
YAD9D020
YAD9D030
NOTICE: REPAIRING ELECTRICAL
SYSTEM
1. While electrical parts is repaired, first of all
separate negative terminal of battery.
Notice: Before separate and link negative terminal,
turn starting switch or all the switch of lamp off (if
switches are not turned off, parts of semi-
conductor may be impaired).
Notice: Memory values of electrical parts may be
erased, so those value should be kept another
place.
2. If harness is interfered by other sharp section, wrap
them, and then, for protecting of harness.
3. While parts is instslled on the vehicle, keep in
mind, in order not to tear or impair to the wiring
harness.
YAD9D010
GENERAL DESCRIPTION
BODY ELECTRICAL 9D-3
SSANGYONG Y200
YAD9D040
YAD9D050
YAD9D060
YAD9D070
4. If fuse is damaged, fuse is replaced by rated
capacity, if fuse is replaced by excessive rated
capacity, parts may be impaired or fired.
7. If connector is connecting loose, this cause to
repair, make sure connecting of connector.
6. Electrical parts are impaired by heat, so if work of
repair should be done excessive temperature of
8°C, remove electrical parts before done this.
5. Sensors and relays should not be influenced by
impact and should not be dropped on the floor.
SSANGYONG Y200
9D-4 BODY ELECTRICAL
YAD9D080
YAD9D090
YAD9D100
YAD9D110
8. While harness is separated, connector should be
pulled, harness should not be pulled, like the
picture.
11. If electric current is sent or check voltage through
tester of circuit, probe is set from the harness, if
connector is kind of sealing type, probe is set
through hole of cap in the wiring rubber.
At this time, keep in mind, not to damage isolation
of wiring, insert probe until contact connector of
terminal completely.
Notice: Tester of circuit is not used on the air bag
system, while this system is checked, scanner
should be used.
10. While connector is linked, insert this until sounds
like tack!, tack!
9. While connector is separated with the lock, pushing
arrow indicated, remove the connector.
BODY ELECTRICAL 9D-5
SSANGYONG Y200
YAD9D120
YAD9D130
Check Cable and Wire
1. Check looseness of the connecting and corrosion.
2. Check the corrosion of terminal and wire by the
eletrolyte.
3. Check open circuit for terminal and wire.
4. Check isolation of wire, damage, deformation.
5. Check interference between parts of terminal and
other metal parts.
6. Check applying an electrical current complete
between fixing bolt and body on the section of
ground.
7. Check lay-out of wiring proper.
8. After fixing wiring completely, wiring should not
be contacting by section of sharpness, section of
high temp. (For example: exhaust manifold,
exhaust pipe).
9. Keep the clearance between wiring and fan- pully,
fan-belt, other parts.
10. After loosening wiring and fix, for vibration
between section of body and the section of engine.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст