SsangYong Rexton. Service manual — part 476
TIRES AND WHEELS 2E-17
SSANGYONG Y200
INSTALLATION
1. Clean the rust, damaged rubber and dust, etc on
the rim’s surface with the brush.
5. Check any foreign material or liquid for the tire
inside and then install to push down the tire.
YAD2E420
YAD2E430
YAD2E440
YAD2E450
2. Install the rim to the equipment with the valve
upward.
3. Tighten the locker in the center of the equipment
to assemble the rim to the equipment.
4. Apply the lubricant at the both bead portions and
both rim’s flange of the tire.
SSANGYONG Y200
2E-18 TIRES AND WHEELS
6. Set the tire pressure to the specifications.
Notice: Do not remove the tire from the equipment
before setting the tire pressure.
YAD2E460
Specification of the
tire pressure
2.1 kg•cm
2
(30 psi)
SECTION 3A
FRONT AXLE
TABLE OF CONTENTS
General Description and Operation . . . ... 3A-2
Front Axle Housing Assembly . . . . . . . 3A-2
Axle Shaft Assembly . . . . . . . . . . 3A-3
Specifications . . . . . . . . . . . . ... 3A-4
Diagnosis Information and Procedures . . .. 3A-5
Component Locator . . . . . . . . . . . 3A-6
Front Axle Shaft . . . . . . . . . . . . 3A-6
Front Axle Housing . . . . . . . . . . ... 3A-7
Vacuum Line . . . . . . . . . . . . ... 3A-10
Maintenance and Repair . . . . . . . . . 3A-11
On-Vehicle Service . . . . . . . . . . . 3A-11
Front Axle Shaft . . . . . . . . . . . .. 3A-11
Vacuum Line . . . . . . . . . . . . ... 3A-18
Axle Housing . . . . . . . . . . . . .. 3A-19
Unit Repair . . . . . . . . . . . . . ... 3A-20
Axle Housing Assembly . . . . . . . . . 3A-20
Differential Joint Assembly . . . . . . . 3A-26
Wheel Joint Assembly . . . . . . . . ... 3A-28
Special Tools And Equipment . . . . . ... 3A-30
Special Tools Table . . . . . . . . . . 3A-30
SSANGYONG Y200
3A-2 FRONT AXLE
GENERAL DESCRIPTION AND OPERATION
FRONT AXLE HOUSING ASSEMBLY
YAD3A020
1 Axle Tube Assembly
2 Snap Ring
3 Ball Bearing
4 Oil Seal
5 Protector
6 Retainer
7 Inner Shaft (LH)
8 Inner Shaft (RH)
9 Bolt
10 Front Axle Bracket (LH)
11 Front Axle Bracket (RH)
The front axle is installed between the left and right
wheel. It have the function which transfers the power
of engine to the wheels. Especially, it transfers the
high power to the front wheels when driving 4-wheel.
The axle shaft connected with CV joint in left/right of
axle and differential carrier in center is installed. The
length of left/right axle shaft is different and the
structure is independent. Both ends part of shaft is
fixed with the spline.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст