SsangYong Rexton. Service manual — part 103
DI10-17
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
DIAGNOSIS
DI ENG SM - 2004.4
Y220_10045
Y220_10046
Y220_10047
4. If you need to change the variant coding, press “
”
key to go back to “VARIANT CODING” screen. In the
screen, select “2] WRITE VARIANT CODING” and press
“
”.
5. When the “VARIANT CODING” screen is displayed,
change the item by using arrow keys.
6. If you press “
”, the message as shown in figure
appears. And, then “VARIANT CODING” screen is
displayed.
7. Select “READ VARIANT VALUE” to see the coding coded
value.
DI10-18
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
DIAGNOSIS
DI ENG SM - 2004.4
Y220_10048
Y220_10049
Y220_10050
ECU Replace
Preceding Work: Perform the “Entering Diagnosis Proce-
dures”
1. Select “9] ECU REPLACE” and press “
” in
“FUNCTION SELECTION” screen.
2. When the “ECU REPLACE (STEP 2)” screen is displayed
followed by “ECU REPLACE (STEP 1) screen, turn the
ignition “OFF” and remove the currently installed ECU.
Notice
Do not turn off the Scan-100 at this time.
Record the below data:
- Vehicle identification number
- Variant coding value
- C2I coding value
- Multi calibration
3. Install the new ECU.
DI10-19
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
DIAGNOSIS
DI ENG SM - 2004.4
Y220_10051A
Y220_10052
Y220_10051
5. In “MULTI CALIBRATION SELECTION” screen, select “2]
DOM/GEN” for automatic transmission equipped vehicle
and select “4] DOM/GEN” for manual transmission
equipped vehicle.
4. If you turn the ignition switch to “ON” position and press “
”, the message as shown in figure 1 (system
initialization) appears, and then “MULTI CALIBRATION SELECTION” screen (fig. 2) is displayed.
6. When you press “
”, the processing message as
shown in figure appears.
figure 1
figure 2
DI10-20
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
DIAGNOSIS
DI ENG SM - 2004.4
Y220_10054
Y220_10055
Y220_10056
Y220_10053
7. If the multi calibration is completed successfully, “ECU
REPLACE (STEP 5) screen is displayed.
Backup data:
- Multi calibration value
- VIN value
- Variant code value
- Injector (C2I) value
8. In immobilizer equipped vehicle, the immobilizer coding
should be done after completed the multi calibration.
9. Press “
” and enter the user password.
10. If the password is invalid, the “access denied” screen as
shown in figure is displayed.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст