SsangYong Rexton. Service manual — part 659
BODY EXTERIOR 9C-9
SSANGYONG Y200
YAD9C070
YAD9C080
YAD9C090
YAD9C100
REPAIR PROCEDURE
HOOD ASSEMBLY
Removal and Installation
1. Release bolt of fixing bracket of shock absorber
in the hood.
Notice: While fixing bracket of shock absorber is
removed, back up hood, to prevent closing of hood
or use another supporting bar to prevent closing
of hood.
3. Remove hose of wiper washer.
4. After releasing fixing bolt of hood hinge, remove
hood assembly.
2. Remove shock absorber. (Method to remove
shock absorber ; refer to replacement shock
absorber of hood)
5. After releasing fixing bolt of hood hinge, remove
hood hinge.
SSANGYONG Y200
9C-10 BODY EXTERIOR
YAD9C110
YAD9C120
YAD9C130
YAD9C140
6. Remove hood latch and cable.
1) Remove cable and hood latch lever in the lower
main panel.
2) Push cable removed through groove of body
into direction of engine room.
3) After releasing fixing bolt of hood latch, remove
latch and cable.
4) Remove cable of hood latch.
7. Install the reverse order of removal .
1) After installing hood hinge into body and hood,
tighten fixing bolt w i t h t h e t o r q u e o f
specification.
Tightening Torque
29 - 39 N•m
(21 - 29 lb-ft)
BODY EXTERIOR 9C-11
SSANGYONG Y200
Bolt of Hood Latch
8 - 11 N•m
(44 - 52 lb-ft)
YAD9C150
YAD9C160
YAD9C170
YAD9C180
2) Install the shock absorber.
Adjusting Hood Hinge
1. Release little bit fixing bolt of hood hinge.
2. After adjusting hood hinge to forward and
backward, left and right, check whether right
position of hood is installed or not.
Adjusting Hood Latch
1. Install hood latch on the right position, if hood latch
is not installed on the right position, while hood is
installed, hood may distort and be unbalanced.
3. After adjusting over slam bumper, adjust height
of front end of hood.
SSANGYONG Y200
9C-12 BODY EXTERIOR
YAD9C190
YAD9C200
YAD9C210
YAD9C220
2. Release a little bit fixing bolt of striker.
3. After adjusting position of striker to forward and
backward, left and right, put center of latch.
Replacement Shock Absorber of Hood
1 . After inserting driver on the upper of bending
equipped both end of shock absorber, get the
bending out of shock absorber, and then, remove
shock absorber.
2. Insert shock absorber, until is sounded like a kind
of equipped sound.
COWL GRILL
Removal and Installation
1. Remove wiper arm and fixing nut of wiper in the
right and left. (M8)
2. Remove weather strip.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст