SsangYong Rexton. Service manual — part 690
SSANGYONG Y200
9D-74 BODY ELECTRICAL
YAD9D2B0
5 Driver Power Seat
Recline Switch
6 Driver Power Seat
Switch
(Slide, Height, Tilt)
7 Seat Heater Control
Unit
1 Slide Adjusting Motor
2 Height Adjusting
Motor
3 Tilt Adjusting Motor
4 Recline Adjusting
Motor
Power seat
Connector and connected circuit
NO.
A1, A2
A3, A4
B1
B2
B3
B4
B5
B6
B7
B11
Size / color
BW
BLACK
WB
Y
GB
RG
BY
GY
BR
GB
Connected circuit
Battery
Ground
Slide
Slide
Tilt
Tilt
Recline
Height
Height
Recline
YAD9D2C0
BODY ELECTRICAL 9D-75
SSANGYONG Y200
YAD9D2E0
YAD9D2F0
Seat warmer switch
Connected circuit
Stics
Summary
Stics which is electron control unit, has the function of
sixteen, if stics is unnormal at the sensor or load, unit
of stics has self –diagnosis.
YAD9D2D0
SSANGYONG Y200
9D-76 BODY ELECTRICAL
YAD9D2G0
FUNCTION OF OPERATION AND
THE CHARACTERISTIC
Intermittent Wiper of Velocity Induction Type
1. Intermittent wiper of velocity induction type which
is linked according to velocity of vehicle,
intermittent time is changed automatically a kind
of wiper system, this one is controlled by below
switch of control.
- Auto switch : which is selected to the intermittent
mode.
- Time control switch of the intermittent : this one
control the intermittent time
- Intermittent time is set (at 0 km/h ) : 2.6 ± 0.5
sec ~ 18 sec ± 2 sec
2. After IGN 2 switch is “ ON” , turn auto switch on,
or after turn auto switch is “ ON” , turn IGN2 on,
immediately, velocity linking mode is operating.
2. While the intermittent wiper is operating, washer
switch is turned on more than 0.6 seconds and
then washer linked wiper is operating, if washer
switch is turned between 0.2 and 0.6, such as
MIST wiper, wiper is operating only once
Washer linking wiper
1. As ignition switch is turning on, if washer switch
is “ON”, after 0.6 second, wiper is operating, after
washer switch is “OFF”, wiper is operating 3 times
and then wiper is turned “OFF”
YAD9D2H0
YAD9D2J0
BODY ELECTRICAL 9D-77
SSANGYONG Y200
YAD9D2K0
YAD9D2L0
YAD9D2M0
Room lamp of light sensitive type
1. As switch of room lamp is set on the position of
door is linked operation, release lock switch of
driver or lock switch of passenger, turn the switch
of ignition (IGN2) “OFF”, and then open up door,
lamp of room is turned on, after door is closed,
after 2 seconds, light is “ON” and then gradually
is sensing light, after 3 seconds approximately,
should be turned off completely.
2. If switch of ignition (IGN2) is turned “ON” or lock
switch of driver seat or passenger is set free, open
up door and then the light is turned on and if door
driver seat and passenger are closed, and
then,immediately should be turned off (Disregard
time of turning on which is less than 0.2 seconds).
3. Capacity of time resolving is more than 32 stem
per 1 seconds.
Function of defogger timer
1. At state of engine which is operated, if switch of
defogger is operated, defogger is operated
(12 minutes).
2. Under defogger is operating, if switch of defogger
is reoperated, operating is stopped.
3. After operation of defogger is finished, within 10
minutes, again switch of defogger is turned on
only once this one is operated for 6 minutes.
(except that switch of defogger is turned off )
4. If ignition switch (IGN2) is “OFF” or if the VOLT of
L terminal of alternator is less than 10 V, operating
of defogger is stopped.
Power window of time delaying
After turn ignition switch (IGN1) OFF, during 30
seconds, switch of power window is operating available
and within this time (30 seconds) if door is opened up,
from at that time, time is extending for 30 minutes,if
door is closed within a time extended, power is “ OFF”.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст