SsangYong Rexton. Service manual — part 362
SSANGYONG Y200
1B3-24 DIESEL ENGINE MECHANICAL
YAD1BB30
YAD1BB40
YAD1BB70
YAD1BB80
Removal & Installation Procedure
1. Remove the tensioning lever nut.
Installation Notice
2. Push the tensioning lever in direction of arrow with
a rod (
φ
12, 180 mm) and push out the bolt to the
rear.
3. Push back the tensioning lever to release the
spring tension and remove the belt.
4. Remove the bolt (9) and then remove the belt pulley
(8).
Installation Notice
5. Remove the bolt (1, 18) and take off the damper
(2).
Installation Notice
Tightening Torque
21 N•m (15 lb-ft)
Pay attention to installation position of the damper.
Tightening Torque
bolt (1) : 21 N•m
(15 lb-ft)
bolt (18): 20 N•m
(15 lb-ft)
Tightening Torque
10 N•m (89 lb-in)
DIESEL ENGINE MECHANICAL 1B3-25
SSANGYONG Y200
YAD1BB90
YAD1BBA0
YAD1BBB0
6. Pull off the tensioning lever (4) from guide rail pin.
7. Remove the spring (17).
Notice: Insert spring (17) with color coding (blue/
violet) facing up.
8. Pry off the closing cover (12) and remove the
socket bolt (11) and then remove the tensioning
pulley (10).
Installation Notice
9. Pry off the closing cover (16) and remove the fit
bolt (15).
Installation Notice
12 . Installation should follow the removal procedure
in the reverse order.
Tightening Torque
29 N•m (21 lb-ft)
Apply loctite on thread of fit bolt.
10. Remove the tensioning lever (14) and washer (13).
11. Clean thread in the timing case cover and fit bolt.
Tightening Torque
100 N•m (74 lb-ft)
SSANGYONG Y200
1B3-26 DIESEL ENGINE MECHANICAL
CRANKCASE AND CYLINDER HEAD
CYLINDER HEAD
YAD1BBC0
DIESEL ENGINE MECHANICAL 1B3-27
SSANGYONG Y200
1 Bolt . . . . . . . . .. 25 N•m (18 lb-ft)+90°
2 Washer
3 Camshaft Drive Sproket . . . . . . . Relace
4 Camshaft
5 Bolt . . . . . . . . . . .. 10 N•m (89 lb-in)
6 Threaded Ring . . . . . .. 130 N•m (96 lb-ft)
7 Prechamber
8 Bolt . . . . . . . . . . .. 25 N•m (18 lb-ft)
9 Camshaft Bearing Cap
10 Cylinder Head Bolt . . . . . . . See Table
11 Plug
12 Engine Coolant Temperature
13 Thermo Valve Sensor
14 Cylinder Block
15 Gasket. . . . . . . . . . . . ... Replace
16 Cylinder Head
17 Sliding Rail
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст