SsangYong Rexton. Service manual — part 642
SSANGYONG Y200
7D-34 AUTOMATIC CONTROL HVAC SYSTEM
COOLANT TEMPERATURE
SENSOR
1. Disconnect the coolant temperature sensor at the
side of the heater core (at left bottom of the glove
box).
2. Installation should follow the removal procedure
in the reverse order.
3. Installation should follow the removal procedure
in the reverse order.
YAD7D340
YAD7D350
SECTION 8A
SEAT BELTS
CAUTION: Disconnect the negative battery cable before removing or installing any electrical unit or when a
tool or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable
will help prevent personal injury and damage to the vehicle. The ignition must be in B unless otherwise
noted.
TABLE OF CONTENTS
Specifications . . . . . . . . . . . . . ... 8A-2
Fastener Tightening Specifications . . . . . ... 8A-2
Diagnosis . . . . . . . . . . . . . . . .. 8A-3
Seat Belt Warning Lamp is Inoperative . . . . . 8A-3
Component Locator . . . . . . . . . . . . 8A-4
Seat Belt Assembly . . . . . . . . . . . . 8A-4
Maintenance and Repair . . . . . . . . . . 8A-5
On-Vehicle Service . . . . . . . . . . . ... 8A-5
Front Seat Belt . . . . . . . . . . . . . . 8A-5
Front Seat Belt Buckle . . . . . . . . . . . 8A-6
2nd-Row Seat Belt . . . . . . . . . . . ... 8A-7
3rd-Row Seat Belt . . . . . . . . . . . . 8A-8
SSANGYONG Y200
8A-2 SEAT BELTS
N • m
30 - 40
30 - 45
30 - 45
30 - 45
30 - 45
30 - 45
30 - 45
30 - 45
30 - 45
30 - 45
Lb-Ft
22 - 30
22 - 33
22 - 33
22 - 33
22 - 33
22 - 33
22 - 33
22 - 33
22 - 33
22 - 33
Front Seat Belt
2nd-Row Seat
Belt
3rd-Row Seat
Belt
Adjuster Mounting Bolt
Retractor Mounting Bolt
Upper Bolt
Lower Bolt
Belt Buckle Bolt
Retractor Mounting Bolt
Upper Bolt
Upper Bolt
Lower Bolt
Retractor Bolt
SPECIFICATIONS
FASTENER TIGHTENING SPECIFICATIONS
Lb-In
-
-
-
-
-
-
-
-
-
-
Application
SEAT BELTS 8A-3
SSANGYONG Y200
Correction
Repair the wiring harness.
Replace the seat belt switch.
Repair the open ground.
Replace the warning lamp bulb.
DIAGNOSIS
SEAT BELT WARNING LAMP IS INOPERATIVE
Condition
Seat belt warning lamp
is inoperative
Probable Cause
Seat belt warning lamp wiring harness is
open circuit or a short circuit.
The continuity between the two terminals
at the switch side of the connector is fail.
The continuity between the terminal for
the BLK wire and ground is fail.
The warning lamp bulb in the instrument
cluster is blown.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст