Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 371
40. Install a new halfshaft snap ring.
41.
CAUTION: Make sure the halfshaft constant velocity (CV) joints
do not over articulate. Failure to follow this instruction may result in
damage to the CV joints.
Detach the halfshaft.
42. CAUTIONS:
Make sure the halfshaft constant velocity (CV) joints do not over
articulate. Failure to follow this instruction may result in damage to the CV
joints.
Make sure the halfshaft seal is not damaged. Failure to follow this
instruction may result in an transaxle fluid leak.
Attach the right-hand halfshaft to the transaxle.
Make sure the halfshaft snap ring is correctly seated.
43. Detach the power steering fluid pipe.
Vehicles with 2.0L engine
44. NOTE: Remove the transaxle plug.
Using the special tool, install a new halfshaft seal.
45.
CAUTION: Make sure the halfshaft constant velocity (CV) joints
do not over articulate. Failure to follow this instruction may result in
damage to the CV joints.
Attach the right-hand halfshaft.
Engage the right-hand halfshaft to the transaxle.
Tighten to 25 Nm.
Vehicles with 2.5L or 3.0L engine
46. Install the transfer case.
For additional information, refer to:
Transfer Case
(308-07 Transfer
Case, Installation).
47. Install the steering gear heat shield.
48. Install the steering gear heat shield bracket.
All vehicles
49. NOTE: Right-hand shown, left-hand similar.
Install the fender splash shield access panel.
50. Install the front subframe.
For additional information, refer to:
Front Subframe - 2.0L NA V6 -
AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27
(502-00 Uni-Body, Subframe
and Mounting System, Removal and Installation).
51. Tighten the right-hand shock absorber and spring assembly securing
nuts.
Tighten to 25 Nm.
52. Tighten the left-hand shock absorber and spring assembly securing
nuts.
Tighten to 25 Nm.
53. Install the air cleaner.
For additional information, refer to:
Air Cleaner
(303-12A Intake Air
Distribution and Filtering - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA
V6 - AJ27, Removal and Installation).
54. Install the battery tray.
For additional information, refer to:
Battery Tray
(414-01 Battery,
Mounting and Cables, Removal and Installation).
55. Check the transaxle fluid level.
For additional information, refer to:
Transmission Fluid Level Check
(307-01B Automatic Transmission/Transaxle - Vehicles W ith: 6-Speed
Automatic Transaxle - AWF21, General Procedures).
56. NOTE: For NAS vehicles only.
If required, carry out a long drive cycle.
For additional information, refer to:
Powertrain Control Module (PCM)
Long Drive Cycle Self-Test
(303-14A Electronic Engine Controls - 2.0L NA
V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27, General Procedures).
Published: 11-May-2011
Automatic Transmission/Transaxle - Vehicles With: 6-Speed Automatic Transaxle -
AWF21 -
Lubricant, Sealers, Solvents and Adhesives
Description
Specification
High-temperature grease
ESD-M1C220-A
Metal surface cleaner
W SW -M5B392-A
Sealant
W SK-M4G320-A
Adhesives
Loctite 243
Fluid Maintenance
CAUTION: Use only C2S-51628 automatic transmission fluid. Use of any other fluids may result in a transmission malfunction or
failure.
Intervals
Normal Maintenance
Not necessary. Filled for life.
General Specifications
Engine
Dry Fill - Approximate Liters
Refil - Approximate Liters
Fluid Type
2.2L
6.6
5.6
C2S-51628
Description
Nm
lb-ft
Main control valve body screws
10
7
Torque converter retaining bolts
60
44
Transaxle retaining bolts
48
35
Emission control valve retaining bolts
30
22
Transaxle support insulator retaining nut
130
96
Transmission control module retaining nuts
24
18
Transmission fluid drain plug
47
35
Transmission fluid filler plug
40
30
Transmission fluid level plug
7
5
Transmission turbine shaft speed (TSS) sensor
6
4
Transmission fluid pan retaining bolts
13
10
Starter motor retaining bolts
35
26
Starter motor solenoid electrical connector retaining nut
6
4
Starter motor electrical connector retaining nut
12
9
W iring harness to camshaft cover retaining stud, retaining nut
6
4
Intake manifold support bracket retaining bolts
10
7
Air cleaner mount bracket retaining nuts and bolt
6
4
Left-hand driveshaft retaining nuts
25
18
Shock absorber and spring assembly securing nuts
25
18
Transaxle ground lead
25
18
Support bar retaining bolts
25
18
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст