Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 155

Published: 11-May-2011

Engine - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 - Valve Cover RH

In-vehicle Repair

Removal

1. Remove the ignition coils. For additional information, refer toSection

303-07A Engine Ignition

Section

303-07B Glow Plug System

.

2. Detach the wiring harness.

3. Disconnect the variable camshaft timing (VCT) solenoid electrical

connector.

4. Remove the engine cover retaining bracket.

5. Remove the intake manifold support bracket.

6. Remove the valve cover.

Remove and discard the valve cover gaskets.

Installation

1. NOTE: Apply a 5 mm diameter bead of silicone gasket sealant
WSE-M4G323-A6 or equivalent meeting Jaguar specification on the half
round gaskets and apply an 8 mm diameter bead of silicone gasket
sealant on the two places where the cylinder head and front timing cover
join.

• NOTE: Make sure that the valve cover isolator mounts are correctly
installed to the new valve cover gaskets.

To install, reverse the removal procedure.

Install the new valve cover gaskets.

Complete the tightening sequence.

Tighten to 10 Nm.

2. Tighten to 6 Nm.

3. Tighten to 6 Nm.

Published: 11-May-2011

Engine - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 - EngineVehicles
With: 5-Speed Manual Transmission - MT75/6-Speed Manual Transaxle - MMT6

Removal

Special Tool(s)

Powertrain Assembly Jack

HTJ1200-2

5 Point Security Torx Bit

418-535

Ball joint splitter

204-192

W heel hub puller

205-491

Adaptor nuts

205-491-01

Forcing screw

204-269

Slide hammer

100-012

Slide hammer shaft

100-012-02

Halfshaft remover fork

204-226

Right-hand halfshaft splitter

307-442

Right-hand halfshaft splitter handle

307-443

Pinion oil seal remover

308-208

Link shaft limiting tool

307-446

Engine lifting kit

303-707

Removal

All vehicles

1. NOTE: Left-hand shown, right-hand similar.

Loosen the front hub retaining nuts.

2. Drain the transaxle.

For additional information, refer to:

Transaxle Draining and Filling -

Vehicles W ith: 6-Speed Manual Transaxle - MMT6

(308-03 Manual

Transmission/Transaxle, General Procedures).

3. Remove the steering column lower retaining bolt.

4. Remove the battery tray.

For additional information, refer to:

Battery Tray

(414-01 Battery,

Mounting and Cables, Removal and Installation).

5. Recover the air conditioning (A/C) refrigerant.